Bolted connection

Bolted connection

A connection between structural members made with plates and bolts, as opposed to a riveted or welded construction.
References in periodicals archive ?
3/1999 ,Quick Make And Break,Interlockable Cover,Uniterrupted Duty,Utilization Category Ac-23A With Three Number High Rupturing Capacity 80 Ka Minimum ,Cartridge Fuses With Bolted Connection,Rated Voltage 415 Volt,50 Hz,Ac,Conforming To Is:13703 Part.
This finding suggests that end distance of 5d would be acceptable as the minimum end distance of LVL bolted connection.
The problem was traced to a bolted connection where the cable passes through the front bulkhead.
97 times the cost of the bolted connection, the welded connection is the recommended one.
The most common bolted connection solution has gusset plates for beam-to-column joints and sleeve or over-lapped systems for beam-to-beam connections.
The FDS Group said the academy would provide accredited and awareness training courses in the processes workers have to follow to achieve and maintain a leak-free bolted connection.
To study the interaction and stresses developed in the threads of a bolted connection 2-D axisymmtric is used.
Thus, for example, bolted connections on high-pressure pipework in a chemical process plant might be denoted as a 'high' consequence asset-if there was a fault with the bolted connection, the consequences could be serious, with the potential for substantial damage and injury or loss of life and the possible additional hazard of severe environmental impact.
But each bolt in that expensive piece of loading, hauling, or process equipment is part of the unit's overall design, specified for a purpose, and improper bolt substitution or misapplication of tightening force on a bolted connection can result in failure, reduced performance, warranty problems, or even unintended disassembly of a vital component.
This meant that the bolted connection between the top section and base segment was in tension as these bolts carried the full cutter load of all the outer cutters.
For a beam with the ends fixed, as in a welded connection or multiple bolted connection, the bending moment is M = wl 2/12.
Tenders are invited for Combination Fuse Switch Units,Rated Current 300 Amp,Metal Clad,Triple Pole With Neutral Link,Degree Of Protection Ip - 2L3,As Per Is/Iec 60947 Part -1/2004 And Is/Iec 60947 Part-3/1999 Quick Make And Brake Interlockable Cover Uninterrupted Duty Utilazation Category Ac-23 A With Three Number High Rupturing Capacity 80 Ka Minimum Cartridge Fuses With Bolted Connection Rated Voltage 415 Volt, 50 Hz Ac, Conforming To Is:13703 Pt.