evaporator (redirected from Evaporators)

evaporator

Industrial apparatus for converting liquid into gas or vapour. The single-effect evaporator consists of a container or surface and a heating unit; the multiple-effect evaporator uses the vapour produced in one unit to heat a succeeding unit. Double-, triple-, or quadruple-effect evaporators may be used in industrial and steam heating plants. Some evaporators are used to concentrate a solution by vaporizing and eliminating water (e.g., in a concentration plant for sugar and syrup). In purification processes such as desalination, evaporators convert the water to vapour, leaving mineral residues behind; the vapour is then condensed into (desalinated) water. In a refrigeration system, the cooling is produced as the rapid evaporation of the liquid refrigerant absorbs heat.

---

evaporator [i′vap·ə‚rād·ər]

(chemical engineering)

A device used to vaporize part or all of the solvent from a solution; the valuable product is usually either a solid or concentrated solution of the solute.

(mechanical engineering)

Any of many devices in which liquid is changed to the vapor state by the addition of heat, for example, distiller, still, dryer, water purifier, or refrigeration system element where evaporation proceeds at low pressure and consequent low temperature.

---

Evaporator

A device used to vaporize part or all of the solvent from a solution. The valuable product is usually either a solid or a concentrated solution of the solute. If a solid, the heat required for evaporation of the solvent must have been supplied to a suspension of the solid in the solution, otherwise the device would be classed as a drier. The vaporized solvent may be made up of several volatile components, but if any separation of these components is effected, the device is properly classed as a still or distillation column. When the valuable product is the vaporized solvent, an evaporator is sometimes mislabeled a still, such as water still, and sometimes is properly labeled, such as boiler-feedwater evaporator. In the great majority of evaporator installations, water is the solvent that is removed.

Evaporators are used primarily in the chemical industry. For example, common salt is made by boiling a saturated brine in an evaporator. The salt precipitates as a solid in suspension in the brine. This slurry is pumped continuously to a filter, from which the solids are recovered and the liquid portion returned for further evaporation. Evaporators are widely used in the food industry, usually as a means of reducing volume to permit easier storage and shipment. Evaporators are also the most commonly used means of producing potable water from sea water or other contaminated sources.

The vaporization of solvent requires large amounts of heat. Provisions for transferring this heat to the solution constitute the largest element of evaporator cost and the principal means of distinguishing between types of evaporators. Practically all evaporators fall into one of the following categories:

1. Submerged-combustion evaporators: those heated by a flame that burns below the liquid surface, and in which the hot combustion gases are bubbled through the liquid.

2. Direct-fired evaporators: those in which the flame and combustion gases are separated from the boiling liquid by a metal wall, or heating surface.

3. Stem-heated evaporators: those in which steam or other condensable vapor is the source of heat, and in which the steam condenses on one side of the heating surface and the heat is transmitted through the wall to the boiling liquid.