printed circuit board
A rigid, flat board that holds chips and other electronic components. The board is made of layers, typically two to 10, that interconnect components via copper pathways. The main printed circuit board (PCB) in a system is called a "system board" or "motherboard," while smaller ones that plug into the slots in the main board are called "boards" or "cards." See flexible circuit.
Etched Circuits
The "printed" circuit is an etched circuit. A copper foil is placed over a fiberglass or plastic base of each layer and covered with a photoresist. Light is beamed through a negative image of the circuit paths onto the photoresist, hardening the areas that will remain after etching. When passed through an acid bath, the unhardened areas are washed away. The finished layers are then glued together. A similar process creates the microminiaturized circuits on a chip (see chip).
Starting in the 1940s
Printed circuits were first used in the 1940s to connect discrete components together. By the 1960s, PCBs were widely used in all electronic systems, but still mostly connecting discrete components. Integrated circuits (chip) were emerging and added to the boards, and by the 1980s, PCBs were holding large quantities of chips. Today, printed circuit boards typically connect mostly chips with only a few discrete components, each chip containing from a few thousand up to hundreds of millions of transistors. See surface mount, via, discrete component, chip, card and motherboard.
 |
 |
| Printed Circuit Boards |
|---|
| The motherboard is the primary printed circuit board in a computer. The drawing at the top shows a Baby AT style motherboard in a PC. The adapter cards plug into the expansion slots on the motherboard. |
| (hardware) | printed circuit board - (PCB) A thin board to which electronic components
are fixed by solder. Component leads and integrated circuit
pins may pass through holes ("vias") in the board or they may
be surface mounted, in which case no holes are required
(though they may still be used to connect different layers).
The simplest kind of PCB has components and wires on one side
and interconnections (the printed circuit) on the other. PCBs
may have components mounted on both sides and may have many
internal layers, allowing more connections to fit in the same
board area. Boards with internal conductor layers usually
have "plated-through holes" to improve the electrical
connection to the internal layers.
The connections are metal strips (usually copper). The
pattern of connections is often produced using photo-resist
and acid etching. Boards, especially those for high frequency
circuits such as modern microprocessors, usually have one or
more "ground planes" and "power planes" which are large
areas of copper for greater current carrying ability.
A computer or other electronic system might be built from
several PCBs, e.g. processor, memory, graphics controller, disk
controller etc. These boards might all plug into a
motherboard or backplane or be connected by a ribbon cable. | |