Encyclopedia

band-pass filter

Also found in: Dictionary, Medical, Acronyms, Wikipedia.

band-pass filter

See filter.
Collins Dictionary of Astronomy © Market House Books Ltd, 2006

band-pass filter

[′band ‚pas ‚fil·tər]
(electronics)
An electric filter which transmits more or less uniformly in a certain band, outside of which the frequency components are attenuated.
(optics)
McGraw-Hill Dictionary of Scientific & Technical Terms, 6E, Copyright © 2003 by The McGraw-Hill Companies, Inc.
Mentioned in
References in periodicals archive
The Muller-Lyer illusion is physically carried in the AM component of single band-pass filtered images in which the illusion is perceived, including images lacking low spatial frequencies.
This model, in turn, is used to forecast and backcast 300 observations, and the 600-term band-pass filter is applied to the resulting series.
The correction of gravity observations with band-pass filters can improve the signal-to-noise ratio of weak signals in the elaboration of long period normal mode seismology.
Under certain fairly weak additional assumptions, the existence of the band-pass filter is implicit in (1) since it implies in effect that we can decompose our stationary time series into components indexed by frequency, [omega].
Weng, "Compact tri-layer ultra-wideband band-pass filter with dual notch bands," Progress In Electromagnetics Research, Vol.
In this paper, the TM01, TM11 and TM21 modes will be employed to realize a third evanescent-mode band-pass filter. It can be found that the maximum value of m is 2, which means, four capacitors are necessary.
The micro-strip lines will perform an effect just like a band-pass filter which can only pass frequencies at 5.15-5.825 GHz from the patch to the ground plane.
Hsieh, "Tri-band band-pass filter with sharp passband skirts designed using tri-section SIRs," IEEE Microw.
DCMA-86 series apply 5.47 - 5.725GHz band-pass filter on DCMA-86III and 5.725 - 5.875GHz on DCMA-86II combining high rejection dielectric resonator design to mitigate unwanted interference signal.
The accelerometers signals are continuously acquired using a 10 kS buffer, a sampling frequency of 10 kHz, and a band-pass filter from 0.5 Hz to 300 Hz (ISO 8041:2005, 2005; UNI ENV 12299, 2003), then the magnitude of the acceleration vector is calculated and the RMS value of each measured component is stored as an indicator of the vibration level.
Copyright © 2003-2025 Farlex, Inc Disclaimer
All content on this website, including dictionary, thesaurus, literature, geography, and other reference data is for informational purposes only. This information should not be considered complete, up to date, and is not intended to be used in place of a visit, consultation, or advice of a legal, medical, or any other professional.