If you don't see a steady stream of clean water exiting the
weep hole, poke a wire hanger into the hole, or spray it out with compressed air, and wet it down again.
Notes: The
weep hole is drilled above the foot valve, but a good distance below the frost line.
A central chip, topped with thermally conducting grease, is surrounded by capacitors and covered with an epoxy bound lid (take particular note of the "
weep hole"--the top of the lid in Figure 3--built into the design).
At first it was assumed that residue from the tile wash had plugged the
weep hole, so it couldn't provide the necessary pressure relief.
Inside the boot there is a
weep hole that needs proper cleaning.
Brumfield recommends demanding full head joints and eliminating the fancy
weep hole designs; instead, allow the bricklayer to leave out head joints entirely every 2 feet or so to act as the wall's drainage system [ILLUSTRATION FOR SKETCH 2B OMITTED].
The MGB highly recommends the landslide mass should be covered with barriers by excavating the overburden material, directing the surface water away from the landslide area by constructing drainage channel along the slope, and installing
weep holes.
David Docherty, by email AYES, these are called "
weep holes" and they are essential to prevent the build-up of water behind the wall.