the top of repair~ extents are currently estimated at 2/3 of the bank height
, but will be reevaluated with hydraulic modeling.
ratio (BHR) was used to quantify the degree of channel incision at all study sites.
We measured channel width, bank height
, and composition (silt, sand, or clay) at each transect.
Because of the pressure gradient in axial direction, the bank height
decreases and the material is conveyed into the direction of the roll ends.
5 row-crop 3 Treatment Silt Sand Average stream Total stream segments Eroding sites Eroding sites bank height
bank length (%) (%) (m) (km) Meandering 28 43 1.
As the bed elevation is lowered through erosional degradation, a reduction in channel slope and increase in bank height
The bank height
is measured by a bank displacement detector.
370 including repairing of guide bunds of Major bridges & their protection works, protection works at erosion/breach prone locations, goods approach road at SPTR and repairing of approach roads at different stations, providing sub-bank in locations having bank height
more than 6m, and other connected ancillary works in between Km 378 to Km 412 in between stations Sripani and Simen Chapori in connection with GC of NLP-MZS section of Rangiya Murkongselek GC Project
We performed an extrusion coating using an extrusion laminator to measure the bank height
under various melt thickness conditions.
was calculated as the side of a right triangle.
We correlated these variables with bank height
and bank width, respectively.
The zone for tree clearing depends on the bank height
, slope, and other site conditions.