base elbow

base elbow

[′bās ¦el‚bō]
(design engineering)
A cast-iron pipe elbow having a baseplate or flange which is cast on it and by which it is supported.

base elbow

A cast-iron pipe elbow having a baseplate or flange cast on it, by which it is supported.
References in periodicals archive ?
Each pump discharge to be supplied with long radius base elbow with adequate support to allow for vertical mechanical joint connection on discharge of pump.
The work under this proposal will include modifications of the piping and appurtenances at the Waterspheroid elevated tank located at the Clearmont Water Plant consisting of, but not limited to, the following: Removal, Disposal, Replacement of above-ground pipe and fittings as described in the contract drawings and located as follows: Approximately 125 feet of the 12-inch fill line from the base elbow to the tie-in connection at the container with Schedule 40 pipe, including the expansion joint.
Tenders are invited for work includes approx 2,370 lf of 6" pvc force main with 6" magnetic flow meter, valves and fittings with wet tap connection to the existing 6" force main; bypass pumping during rehabilitation, removal of existing 4" force main after the new force main is in operation, and restoration of the site, rehabilitation of existing wet well, demolition of underground valve box and its replacement with an aboveground valve pad, replacement of the base elbows, discharge piping, guiderail system, valves / fittings, electrical and rtu panels and antenna.
The project consists of the rehabilitation of Lift Station T-26 to include rehabilitation of existing wet well; demolition of underground valve box and its replacement with an aboveground valve pad; replacement of the pumps, base elbows, discharge piping, guiderail system, valves and fittings, electrical and RTU panels; installation of an electrical demarcation box and connection to the existing force main.
The project consists of Rehabilitation of LS T-25, which includes rehabilitation of existing wet well; replacement of pump base elbows, discharge piping, guide rail system, valves, fittings, valve box with valve pad, a short length of force main, SCADA system and electrical panel; removal and storage of the existing submersible pumps and installation of two out of three existing pumps into the wet well for conversion to a duplex installation; demolition of valve vault, pig launcher; installation of emergency generator with belly tank and automatic transfer switch, bypass pumping of the lift station during rehabilitation of wet well, and all other incidentals necessary to complete the work in accordance with the Contract Documents.
Tenders are invited for The work includes remove pumps controls, and base elbows in lift station no.
The construction of the pump station includes the installation of a 4~ diameter control manhole, 8~ diameter precast wetwell, pre-fabricated building to include all process piping, valves, controls, HVAC, cast in place foundation walls for building; installation of three submersible raw wastewater pumps and associated base elbows, slide rails, floats; new natural gas generator, gas piping, electrical service, SCADA equipment, SCADA tower, paved drive, concrete sidewalk, chain link fence, slide gate, and all of other miscellaneous equipment and material.