bend test

bend test

[′bend ‚test]
(metallurgy)
A ductility test in which a specimen is bent through an arc of known radius and angle.
References in periodicals archive ?
Tire Rack's South Bend test track provides a surface for wet and dry road simulations, as well as maneuvering challenges, such as 90-degree corners, ramps and a five-cone slalom.
Apple has another PR crisis up its way for its newly launched iPad Air 2 courtesy of a YouTube user named Martin Macht who did a bend test on the device.
He then performed a bend test on the phone using his bare hands.
Certainly Apple has a range of robots that put new devices through a series of rigorous tests - and a bend test would be on that list for sure.
Coatings subjected to a 1/2 inch mandrel bend test after aging.
The creep test specimens were nominally identical to the quasistatic bend test specimens.
Bending tests were performed according to the ASTM D522 standard, "Mandrel Bend Test, Method B, and Cylindrical Mandrel.
The three-point bend test has been used to determine the most important features of this test.
The configuration for the boards for the bend and drop tests essentially follows JESD22-B111 (1) with minor differences in the number of components placed, since the same board design was used for both the drop and bend test.
Arotran 720 is a toughened "medium-density" Class A system that reportedly gives 90% fewer paint pops than standard Class A SMC by the mandrel bend test.
From each test sheet a strip of 100-200 mm width is cut out, from which specimens are made (1 for tensile strength; 3 for impact bend test for each temperature; 3 for impact bend after mechanical ageing; 2 for bend test, and 3 if thickness exceeds 30 mm; 4 for testing ductility of corrosion-resistant layer; 1 for bend test of wide specimens; 1 for fracture test; 1 for shear test; 1 for checking thickness of corrosion-resistant layer; 1 for checking microstructure; for intercrystalline corrosion test (ICC) number of specimens is established according to GOST 6032-84 from each melting of corrosion-resistant layer in a lot).