bituminous coating

bituminous coating

[bī′tü·mə·nəs ′kōd·iŋ]
(materials)
A coating made principally of bituminous material and used as a surfacing for roads and as a water-repellent barrier in buildings.

bituminous coating

An asphalt or tar compound used to provide a protective finish for a surface.
Mentioned in ?
References in periodicals archive ?
After cleaning, protect the bare metal inside the box with bituminous coating compound, NSN 8030-00-290-5141.
Inadequate adhesion of bituminous coating and grit, poor quality substrate, deterioration rates higher than that put forth in warranties, and inadequate sealing strip are all problems associated with defective manufacture.
Damproofing materials include a bituminous coating over Portland cement (often applied to unit masonry foundation walls), thicker bituminous coatings, cementitous coatings, bonding mortars, acrylic latex coatings, or 6 mil polyethylene.
You can also use bituminous coating, NSN 8030-00-290-5141, if the epoxy is not available.
First the culvert was cleaned and the bituminous coating removed where possible.
5 & 6m for classification K9 suitable for push -on-joint (Rubber gasket D jointing) with cement mortar lining inside the pipes with outside /Inc and bituminous coating rates are ex -factory excluding transportation, taxes and duties.
1,200 cm core drilling, 550 m 2 shot peening, 530 m 2 gradient concrete, 20 m 2 gradient filling, 550 m 2 protective films, 550 m 2 2-ply bituminous coating on primer, 120 m 2 base sealing elevators h = 90 cm with throat formation, 430 m of thermal insulation xps wlg 040, 60 mm, 430 m 2 thermal insulation xps wlg 040, 80 mm, Place 5 pcs of roof drains provided in the tg ceiling and seal them.
approximately: Heavy roads 6 000m bituminous coating and 4 000m of honeycomb / gravel, 450 m 3 wall gabion).
Quotation are invited for Preparation of Jharkhand Scheduled of Rate for Centrifugally Cast (Spun) Ductile Iron Pressure Pipes Of 100 Mm And Above All Diameter For Water With Socket & Spigot Ends Confirming To Is 8329/2000 In Standard Working Lenghts Of 4 5,5,5 & 6M For Classification K7 Suitable For Push -On-Joint Rubber Gasket D Jointing) With Cement Mortar Lining Inside The Pipes With Outside Zinc And Bituminous Coating Rates Are Ex -Factory Excluding Transportation, Taxes And Duties
Improvement of the infrastructure with a layer of asphalt 10 cm thick (7cm of bituminous coating + 3cm of layer of equalization in asphalt aggregates) and d A layer of untreated gravel 20 to 40 cm thick