box nail

box nail

A nail similar to a common nail but thinner; has a long shank which may be smooth or barbed.
References in periodicals archive ?
While a box nail might always be a box nail, many other products--light bulbs, for example--change rapidly.
3 inches; 2) the box nail surface was smooth, where there was limited surface contact and mechanical interlocking between wood fibers and the nail, and it caused little fiber separation; 3) even with 16d common nails, few wood failures in the tested connections were found.
Similar in shape to the box nail but with a thicker shaft; for heavy-duty construction tasks such as framing.
6 Center the walls on the footing plates and tack the corner studs together with a 16d galvanized box nail.
gap at the end, and nail at each stud with s single 8d galvanized box nail held 1 in.
html) HERE to see a photo of the Gift Box Nails as well as a step-by-step tutorial from Syl and Sam.
Attach to the carriage with two 8d box nails at each carriage.
These expanded and reinforced ends can be assembled using 1 1/2" long #5, flat-headed wood screws and 3"-long, 2d box nails.
common-nails - similar to box nails, but larger in diameter (Fig.
galvanized pipe Four 6" heavy-duty tension springs Four 4"x5/16" eyebolts, nuts and double washers One hundred 1-1/2" #8 flathead wood screws 30"x36" rectangle of plastic grass carpet 4' length of 3/4"-diameter hemp rope One pound of 3" galvanized box nails Roll of 3/4" plastic tape Dog leash 12"x12" square of dark-colored Naugahyde 12"x12" square of red felt 5/8" staples
corner boards) 10 1x6 x 10' (backfill boards) 2 1x4 x 10' (liner clamp board) 2 4x8 x 1/2" plywood (pond sheathing) 1 Cedar (rough sawn) for trellis: 2x6 x 8' (posts, rails and cap) 6 2x2 x 8' (horizontal lattice, frieze boards) 5 2x2 x 10' (vertical lattice) 2 Pond trim: 2x4 x 8' (corner boards) 2 6" x 12' siding 6 2x10 x 10' (top cap) 2 Hardware: 3" box nails (treated wood-rated) for framing 1 lb.