I then drilled a cross hole
in the side of the rod about 3/8" back from the face so I would not have a blind .
In addition, the cross hole
to member end distance was increased to 6 inches.
However, the cross hole
drilled through the center of the rectangular tenon to accommodate the cross member considerably altered the mechanical characteristics of the section and weakened it.
Live tools provide drilling (including deep-hole, cross hole
and bolt-hole pattern), flat and keyway milling, counterboring, slotting, rolling, knurling, sawing, deburring, broaching, and even thread cutting.
It can handle workpieces with interrupted cuts, cast skin, or cross holes
The ability to perform more fine-hole micromachining, corporate bigwigs said, will allow the firm to better machine intersecting or cross holes
in various configurations.
Inline and offset output shafts that can be custom machined with cross holes
, splines, keyways, and flats, or end drilled and tapped.
Whether performing circular or straight-line measurements, the device detects interruptions such as grooves and cross holes
automatically, regardless of their position, and the corresponding profile interruptions are not evaluated.
Operations include boring holes in the ears and milling flats on the ears, both inside and outside, ring grooving, boring, and reaming the cross holes
where the pin goes through.
Northing) (m) (m) (m) (ft) g/tonne oz/ton (X) CROSS HOLES OA-RC-01 9,700 9 28 19 62 3.
Spacing cross holes
1-1/2 inches apart, however, leads to strength reductions of near one-half.
Thread milling eliminates secondary operations Burring is a major problem that companies experience when tapping intersecting cross holes