The

distribution curve was found to depend on many processing variables that included nitrogen ratio, milling rpm, mill gap and sieving technique.

They include: the number of samples with prevailing snowflake type; the percentage corresponding to the number of snow elements in snowflakes, N(SCSF), divided by the total number of snow elements (individuals and in the snowflakes), Ntot; mean and maximum number of snow crystals in a snowflake (SC in SF); the mean sizes of snowflakes corresponding to the accumulated mean size occurrences (assuming usually the applicability of the combination of two normal

distribution curves); size of the snowflake and the accumulated percentage corresponding to the slope change in the normal

distribution curve.

The failure pressure decreases, and the corresponding

distribution curve migrates to the left with time.

The standard

distribution curve illustrates the weight variations.

A wringlet may cause the introduction of a discontinuity in the lift

distribution curve" versus "A wringlet may introduce a discontinuity in the lift

distribution curve.

Northwest Diagnostic was found to differ significantly from the average E&M distribution published by Texas Blue Shield, with a bell-shaped E&M

distribution curve that is shifted to the right.

If you did a heel analysis on someone at the drugstore, then brought them into a DEXA machine that has a good referent database, where they fall on that

distribution curve can change enormously," she said.

According to Steimle, the narrow-band discrimination of spectrophotometers is more valuable for brighter colors because the brighter the color, the sharper the peak of its spectral

distribution curve.

Rankings range from five stars (highest) to one star (lowest) and follow a normalized

distribution curve.

The power consumption, luminous flux, luminous intensity

distribution curve and spectral characteristics of the luminaires were measured at Aalto University Lighting Unit.

The important ranges of size (for either independent particles or agglomerates) for different film attributes are shown in Figure 5, along with an idealized particle size

distribution curve that is representative of current production capabilities.

With a product

distribution curve this steep, approximately 40 percent of the products are either at breakeven status or are losing money on a fully loaded basis.