drawing die

drawing die

[′drȯ·iŋ ‚dī]
(metallurgy)
A die that forms sheet metal into cuplike, wrinkle-free shapes.
References in periodicals archive ?
The drawing speed was 15 m/min and the angle of drawing die was [delta] = 28[degrees].
Hamada, T, Harada, K, "Optical Fiber Drawing Die and Drawing Method Therefore.
They set up a test on a 12" x 12" x 6" -inch-deep drawing die in D2 die steel.
A positive influence of restriction of drawing die angle from 13[degrees] to 11[degrees] at the bunching process was found.
Tenders are invited for Supply of tungsten carbide tube drawing die of bore size 19.
Here, a drawing die set is aligned by means of a milled keyway in the center of the bolster that mates with a key attached to the lower die set.
The factory also manufactures diamond wire drawing dies, which are used at ACS' Monterrey, Mexico, plant and sold to other wire producers.
UGS has announced that Radkersburger Metallwarenfabrik, an Austrian-based die manufacturer, has selected NX(TM) CAM Express software for manufacturing its deep drawing dies.
Wire EDM is applied in manufacturing of progressive dies, blanking dies, extrusion dies, and drawing dies.
Usually, diamond drawing dies are used in wire manufacture to produce smooth, perfectly round wire with tolerances of |+ or -~0.
IIT Madras selected sp3's Model 650 to explore CVD diamond's ability to improve the wear resistance of the drawing dies that are used by the Murugappa group of Industries.