long screw

long screw

A pipe nipple usually 6 in. (15 cm) in length, with one thread much longer than usual.
Mentioned in ?
References in periodicals archive ?
Make sure that the part is not being filled or packed during screw rotate or plastication if you have to run with a long screw delay before screw rotation.
On the PSt, the stock is held in place with one wood screw through the tang and one long screw up through the bottom of the grip on the thumbhole stock.
The "M" manual tools develop a clamping force as an operator physically turns a handle on a long screw.
Based on long screw compressor production history and experiences, Kobelco has developed an aluminum winding motor mounted inverter controlled integral type two stage NH3 screw compressor.
For the blind flooring, I used 3-inch-by-5-inch-by-8-foot landscape timbers," he said, "To hold them in place, I used 3-inch long screw bolts extending upward through the angle iron of the original spreader frame and into the timbers.
I have since learned from them that the reason for the barrel coming out was that when Safestyle UKfitted the door the long screw which would have held the barrel in place, had never been fitted.
Long residence time in the molten stage because of an excessively long screw increases degradation of the polymer, and the properties of the material will be negatively affected.
However, it is also important to thoroughly mix the regrind, and at current throughput rates, a long screw is required.
Replacement of this system with a long screw entering the front sight housing from the bottom (through the existing mounting screw hole), produced the more familiar and far superior Patridge-type sight picture.
Tenders are invited for Supply of misc water supply materials for(cpvc pipe, cpvc bras fittings, long screw, g.
These results suggest that 45 mm long screws should be selected for construction of cases of MDF to achieve maximum stiffness, while for PB 50 mm long screws should be selected when 4 mm and 5 mm diameter screws considered and 45 mm long screw for 3.
CTE's technology has one short and one long screw side by side, changing from a twin-screw kneader to a single-screw extruder.