dip coating

dip coating

[′dip ‚kōd·iŋ]
(engineering)
A coating applied to ceramic ware or metal by immersion into a tank of melted nonmetallic material, such as resin or plastic, then chilling the adhering melt.
References in periodicals archive ?
The student will receive training in a broad spectrum of techniques ranging from AFM, rheology, surface deposition (spin and dip coating), QCM, NMR and spectroscopic techniques available in SPS, alongside working with collaborators at large-scale neutron and X-ray scattering facilities in Oxfordshire and France.
For practitioners to readily accept such alternative technology, the goal must be to use the same or similar dipping equipment used in RFL dip coating programs.
To demonstrate the effectiveness of some of the series, several IPC-B-25A multipurpose test boards were treated with two coatings (noted herein as 7.0 and 8.4) using two different methods: rod and dip coating. IPC-B-25A multipurpose test boards were selected per recommendation from the guidelines for testing solder masks (IPC-SM804C) and for testing conformal coatings (IPC CC-830B).
Compared with electrospinning method, the dip coating is the earliest, simplest, and most economical technique to produce polymer thin films because of the limited amount of polymer solution and equipment necessary [43]; therefore, dip coating is extensively used to apply a buildup layer for research purposes.
Before bundling, a soft polymer layer and an outer epoxy resin shell were placed around the fibre by a dip coating process (DipMaster, Chemat Technology Inc., USA).
MDI offers expertise in plastic and rubber processing including dip molding, dip coating and injection molding.
The sol-gel method is easily coupled with several coating techniques, such as spray coating, spin coating, or dip coating [15].
Both spray and dip coating options are available as well as primerless options using Arkema's patented Kynar ADX technology.
The deposition of transparent contact of ZnO:In was realized for dip coating method, using zinc acetate dehydrate, 2-methoxiethanol, monoethanolamine (MEA), and indium chloride as source solutions.
The fluorinated silica sol was applied on aluminium by dip coating. After dip-coating the substrates (aluminium), the coatings were cured for 1 hour at 1200 C.
Application techniques for coating plastics are similar to those used for metals, i.e., conventional air spray, airless, electrostatic (guns or bells), flow coat or even dip coating. However, conductive primers are needed if topcoats are to be applied electrostatically.
Firstly to attain a satisfactory black appearance while maintaining adequate thread preciseness, it was decided to use the chemical conversion film, which used to be applied as a finish treatment on a zinc plating, as an undercoat before dip coating. Then, taking advantages of the color of the undercoat, such a paint has been developed that can ensure evenness of color even from one-time painting by controlling the amount of pigment in the paint.