approximately 384 m 2 external wall insulation, mw, wlg 035, wap, d 180 mm, approximately 34 m 2 thermal insulation exterior wall, xps, wlg 028, wap, d 140 mm, as base, approximately 36 m 2 thermal insulation inside wall, mw, wlg 050, wi, d 100 mm, approximately 15 m 2 thermal insulation inside ceiling, mw, wlg 050, wi, d 140 mm, approximately 70 m base end profile drip edge
plastic, approximately 100 m plasterboard etics, connection joint b up to 5 mm, approximately 137 m connecting joint, permanently elastic sealant, approximately 38 m 2 coating underside concrete canopy.
The fascia boards are more likely to be rotting from another cause: Roof water following surface tension along the metal drip edge
and getting into the fascia boards joints (boards that were most likely installed "raw," unprimed) over a long period of time as is too often the case.
BlockNet creates a continuous stainless steel drip edge
around the building perimeter.
Metal-Era received FM ratings on a wide range of fascia, coping and drip edge
products including their Anchor-Tite, Perma-Tite and Edge Systems One product lines.
If you do not provide a drip edge
, water stains the surface of the balcony face.
An average ice dam is 4 to 5 inches thick at the drip edge
and extends back up the roof about 6 inches.
The drip edge
(AA) installed under the shingles will overlap all the top trim boards and cover any imperfections.
A metal flashing with drip edge
spans the brick veneer and cavity, turns up the back-up wall, and is counterflashed by the water barrier.
All aluminum drip edge
, ridge vent and flashing are also recycled.
With a hacksaw, cut the aluminum drip edge
that will protect the plywood edges.
Many installers believe that increasing the overhang on the first course of shingles helps direct water into the gutter and is a substitute for a metal drip edge
Vented drip edge
, continuous soffit vents, under eave vents and mini louvers complete its product offering.