electric power substation

(redirected from Electrical substation)
Also found in: Wikipedia.

electric power substation

[i¦lek·trik ¦pau̇·ər ′səb‚stā·shən]
An assembly of equipment in an electric power system through which electric energy is passed for transmission, transformation, distribution, or switching. Also known as substation.

Electric power substation

An assembly of equipment in an electric power system through which electrical energy is passed for transmission, distribution, interconnection, transformation, conversion, or switching. See Electric power systems

Specifically, substations are used for some or all of the following purposes: connection of generators, transmission or distribution lines, and loads to each other; transformation of power from one voltage level to another; interconnection of alternate sources of power; switching for alternate connections and isolation of failed or overloaded lines and equipment; controlling system voltage and power flow; reactive power compensation; suppression of overvoltage; and detection of faults, monitoring, recording of information, power measurements, and remote communications. Minor distribution or transmission equipment installation is not referred to as a substation.

Substations are referred to by the main duty they perform. Broadly speaking, they are classified as: transmission substations, which are associated with high voltage levels; and distribution substations, associated with low voltage levels. See Electric distribution systems

Substations are also referred to in a variety of other ways:

1. Transformer substations are substations whose equipment includes transformers.

2. Switching substations are substations whose equipment is mainly for various connections and interconnections, and does not include transformers.

3. Customer substations are usually distribution substations on the premises of a larger customer, such as a shopping center, large office or commercial building, or industrial plant.

4. Converter stations are complex substations required for high-voltage direct-current (HVDC) transmission or interconnection of two ac systems which, for a variety of reasons, cannot be connected by an ac connection. The main function of converter stations is the conversion of power from ac to dc and vice versa. The main equipment includes converter valves usually located inside a large hall, transformers, filters, reactors, and capacitors.

5. Most substations are installed as air-insulated substations, implying that the bus-bars and equipment terminations are generally open to the air, and utilize insulation properties of ambient air for insulation to ground. Modern substations in urban areas are esthetically designed with low profiles and often within walls, or even indoors.

6. Metal-clad substations are also air-insulated, but for low voltage levels; they are housed in metal cabinets and may be indoors or outdoors.

7. Acquiring a substation site in an urban area is very difficult because land is either unavailable or very expensive. Therefore, there has been a trend toward increasing use of gas-insulated substations, which occupy only 5–20% of the space occupied by the air-insulated substations. In gas-insulated substations, all live equipment and bus-bars are housed in grounded metal enclosures, which are sealed and filled with sulfur hexafluoride (SF6) gas, which has excellent insulation properties.

8. For emergency replacement or maintenance of substation transformers, mobile substations are used by some utilities.

An appropriate switching arrangement for “connections” of generators, transformers, lines, and other major equipment is basic to any substation design. There are seven switching arrangements commonly used: single bus; double bus, single breaker; double bus, double breaker; main and transfer bus; ring bus; breaker-and-a-half; and breaker-and-a-third. Each breaker is usually accompanied by two disconnect switches, one on each side, for maintenance purposes. Selecting the switching arrangement involves considerations of cost, reliability, maintenance, and flexibility for expansion.

A substation includes a variety of equipment. The principal items are transformers, circuit breakers, disconnect switches, bus-bars, shunt reactors, shunt capacitors, current and potential transformers, and control and protection equipment. See Circuit breaker, Electric protective devices, Electric switch, Relay, Transformer

Good substation grounding is very important for effective relaying and insulation of equipment; but the safety of the personnel is the governing criterion in the design of substation grounding. It usually consists of a bare wire grid, laid in the ground; all equipment grounding points, tanks, support structures, fences, shielding wires and poles, and so forth, are securely connected to it. The grounding resistance is reduced enough that a fault from high voltage to ground does not create such high potential gradients on the ground, and from the structures to ground, to present a safety hazard. Good overhead shielding is also essential for outdoor substations, so as to virtually eliminate the possibility of lightning directly striking the equipment. Shielding is provided by overhead ground wires stretched across the substation or tall grounded poles. See Grounding, Lightning and surge protection

References in periodicals archive ?
The first fire crews were on the scene within four minutes and neighbouring buildings were then evacuated and additional crews requested when the arriving crew saw the fire had spread to an electrical substation, with potential to spread to nearby buildings.
A 66kV plant was inaugurated in Hajjiyat; a 220kV substation was launched as part of the Bahrain International Airport station; and a 66kV electrical substation was made operational as part of the airport's western plant.
The EUR 20mn ($25mn) contract consists of an electrical substation and an associated transmission line which will enable part of the energy consumed in the country's south west to be supplied in a more efficient and sustainable way.
The blaze broke out at an electrical substation close to the buildings on Renfrew Street and Renfield Street.
Pleaded guilty to damaging an electrical substation, of an unknown value, belonging to NEDL on October 19.
This Company for sale is a privately owned and operated specialist in electrical substation testing, maintenance, and commissioning.
Also assembly of transmission 138 kV (kilovolt) lines will be made to link these to the National Interconnected Electrical Substation These works will improve the electricity for residents of the western and northern parts of Nicaragua.
Most recently, the producer fabricated structures for four elevated electrical substation sites along a pipeline running from Texas to Oklahoma.
The Indura electrical substation IEC 61850-3 certified switch, designed and engineered for Smart Grid and electrical substation infrastructures, now includes IND-328x-H high-voltage versions.
Employees of the EVN power distribution company replaced a safety fuse in a Burgas electrical substation around 1:11 am on Tuesday, as EVN had received a call from local residents that smoke was coming out of it.
POWER was cut to a retail park after a lorry lost control on a patch of ice and crashed into an electrical substation.
The recent launch of Alcomet's innovative Guardian Security Product range has been much in demand following its development in partnership with electrical substation specialist engineers.