feed ratio

(redirected from Feed Ratios)
Also found in: Financial.

feed ratio

[′fēd ‚rā·shō]
(mechanical engineering)
The number of revolutions a drill stem and bit must turn to advance the drill bit 1 inch when the stem is attached to and rotated by a screw- or gear-feed type of drill swivel head with a particular pair of the set of gears engaged. Also known as feed speed.
Mentioned in ?
References in periodicals archive ?
Subsequently, binary vinyl monomers of MMA and EA in the varied feed ratios were grafted onto acid soluble collagen (ASC) with the aim of benefiting from the firmness and the plasticizing capacity of the resulted copolymer.
According to the calculated data, the relative stress triaxiality for different ball diameters, amounts of thinning, and feed ratios is analyzed and discussed as follows.
Relation between Particle Size, Zeta Potential, Drug Loading, and Entrapment Efficiency of DZP-CHP NPs and Feed Ratio. The prepared CHP NPs were loaded with donepezil according to different feed ratios, and particle size and zeta potential were measured by dynamic light scattering.
8 we plotted a graphical representation of the single-layer and bilayer pressure gradients as a pressure distribution within the coating gap including different feed ratios m.
The objective of the study was, therefore, to compare the effects of water restriction on BW gains, feed intake, feed conversion ratio and water to feed ratios of NNK and OVB chickens.
The experimental runs operating conditions were designed so to test five different manure/OJW feed ratios, on a mass basis (Table 2).
CP 2 and CP 3 samples were prepared by varying the feed ratios of BaS[O.sub.4] and cellulose to 2: 1 and 3: 1, respectively, using the same manner as described previously.
The copolymers were designed to have different feed ratios of comonomer units (benzothiadiazole and triazole).
The daily feed ratios of the cows in lactation contained 60% roughage feed and 40% concentrate feed.
Table 1 -- Codes and Molar Feed Ratios of Polyester and Silicone-Modified Polyester (Unit: %) Sample No.
Six consecutive workpieces were machined using three different feed ratios one workpiece conventional and one with application of climb direction of milling.
If anyone needs help figuring the feed ratios we would be glad to help.