gear teeth


Also found in: Dictionary, Thesaurus, Legal.

gear teeth

[′gir ‚tēth]
(design engineering)
Projections on the circumference or face of a wheel which engage with complementary projections on another wheel to transmit force and motion.
References in periodicals archive ?
This shows oil gets flung of by the gear teeth, which will have an advantage of lower churning losses.
The gear was then modeled by using a combination of the scanner software and Inventor, where Inventor was used only when the average tooth depth of the gear teeth was to be modeled.
This observation is well correlated with the location of the wear observed on the gear teeth. The Contact Pressure decreases when the tooth correction increases, especially the root relief.
A novel concept of using twin complementary cathode gears was conceived to (i) ensure finish of the entire face width of the bevel gear teeth with reciprocating motion as required in the finishing of the cylindrical gears by ECH, and (ii) ensure the inter electrode gap (IEG) between the workpiece and cathode gears so that short-circuiting between them is avoided.
The system uses lightweight, motorized drive rollers with drive gear teeth formed directly into the rollers.
Abstract: This paper presents the parametric optimization of Electrochemical Honing (ECH) of gears using Response Surface Methodology (RSM) and Simulated Annealing Algorithm (SAA) to predict the surface quality of gear teeth profile.
Apart from complex gear teeth surfaces, the system can inspect turbine blades, digital camera housings, complex closures and more.
The WQ pumps introduced Haldex's concept of true dual-flank engagement of the gear teeth, which reduces the amplitude of the pressure pulsations introduced into the hydraulic system.
Steps 25 and 26 in WP 0098 00-16 of TM 9-2350-256-20-1 (Nov 05) have you use a screwdriver and a piece of wire to lift and push the coupling flange toward the steer clutch housing while also using a second screwdriver to turn the steering tie shaft to engage the gear teeth.
This company offers everything from casting a gear box to carburizing gears and CBN finishing of the gear teeth. State-of-the-art product design technology is said to enable the elimination of potential problems prior to entering the production phase.
It fits inside a flex spline, a steel cup with gear teeth on the outside of its thin walls that deform to take on the wave generator's elliptical shape.