Mercury-Vapor Lamp

(redirected from Mercury vapor)
Also found in: Dictionary, Thesaurus, Acronyms.

mercury-vapor lamp

[′mər·kyə·rē ¦vā·pər ‚lamp]
A lamp in which light is produced by an electric arc between two electrodes in an ionized mercury-vapor atmosphere; it gives off a bluish-green light rich in ultraviolet radiation. Also known as mercury lamp.

Mercury-Vapor Lamp


a gas-discharge light source in which an electric discharge in mercury vapor is accompanied by optical radiation in the ultraviolet, visible, and near-infrared regions of the spectrum. Mercury-vapor lamps are subdivided into low-pressure, high-pressure, and superhigh-pressure lamps according to the operating pressure. This pressure in turn depends on the temperature of the coldest section of the arc tube and the quantity of mercury introduced into the tube.

Low-pressure lamps, wherein the pressure is approximately 0.7 newton per square meter (N/m2), are efficient sources of resonance mercury radiation at wavelengths of 185 to 254 nanometers (nm). The most widely used lamps in this group are fluorescent lamps and bactericidal lamps.

High-pressure mercury-vapor lamps (104–106 N/m2) are efficient light sources that radiate predominantly in the ultraviolet and visible regions of the optical range. The spectra of these sources have a lined appearance with spectral lines in the wavelength range of 248 to 1,014 nm. The arc tubes of high-pressure lamps, which have a diameter of 8–60 mm and a length of 30–1,500 mm, are made of refractory, transparent quartz glass and are filled with an inert gas and a certain quantity of mercury. When the lamp is in operation, the mercury within the tube evaporates completely and creates the required pressure. The discharge is a bright arc that strikes across the electrodes along the axis of the tube. At pressures exceeding 105 N/m2, there appears a continuous background of radiation, whose intensity increases with the current density and pressure. The power ratings of high-pressure mercury-vapor lamps range from 50 watts (W) to 50 kilowatts (kW); their luminous efficiency is 40–60 lumens per watt (lu/W). High-pressure mercury lamps with outer bulbs coated on the inside with a phosphor are used for lighting. Lamps without a phosphor coating are utilized in medicine (phototherapy) and photochemistry and in photocopying apparatus.

Superhigh-pressure mercury-vapor lamps (above 106 N/m2) are sources of very bright radiation in the ultraviolet and visible regions. Their spectra have a lined appearance with the most intense lines corresponding to wavelengths of 312 to 579 nm. In both the ultraviolet and visible regions, a continuous radiation background is superimposed on the lined spectrum, and the intensity of the background increases with the current density and pressure. Superhigh-pressure lamps can have natural cooling or water cooling, according to which the arc tube will be, respectively, spherical or capillary. The power ratings of superhigh-pressure mercury-vapor lamps range from 100 W to 10 kW, and their luminous efficiency is 30–70 lu/W. These lamps are used in various optical apparatus.

Among the high-pressure and superhigh-pressure mercury-vapor lamps, the metallohalogen lamps are of particular interest. Here, the halides of certain metals are added to the arc tubes in order to increase significantly the efficiency and to vary within wide limits the spectral composition of the radiation.

Special starting and regulating devices must be used in connecting all mercury lamps to circuits.


Rokhlin, G. N. Gazorazriadnye istochniki sveta. Moscow-Leningrad, 1966.
Rtutnye lampy vysokogo davleniia. Moscow, 1971. (Translated from English.)


mercury-vapor lamp

An electric-discharge lamp consisting of an electric arc in mercury vapor in a sealed tube, which in turn may be enclosed in an outer glass envelope; the light produced appears to be blue-white, but contains only violet, blue, green, and yellow components. The lamp is said to be “low pressure” if the partial pressure of the vapor is below 0.001 atmosphere, and “high pressure” if about an atmosphere.
References in periodicals archive ?
Spot air sampling found mercury vapor concentrations of 0.2-6.8 [micro]g/[m.sup.3] outside of processing areas, with differences of up to 1 f g/[m.sup.3] between ground level and breathing height measurements; higher mercury levels at the ground were reported, compared with breathing height (Table 2).
Significant models adjusted for age and duration of mercury vapor exposure fit better (based on OR level) compared to the models based only on genotypes of polymorphic variants of genes.
Descriptive statistics (means and SD) were used to characterize the difference between exposed and unexposed groups including demographic characteristics, mercury vapor levels, and urinary mercury concentrations, frequencies, and percentages.
The LSRO report, however, does refer to animal experiments in which exposure to high levels of mercury vapor led to behavioral deficits in offspring.
A high efficacy ceramic metal halide 360 watt lamp is available in the marketplace that is a retrofit on mercury vapor gear.
Broken lamps should not present a hazard if managed in accordance with basic clean-up procedures, including ventilating the area, removing all glass shards, and avoiding vacuuming, which can spread the mercury vapor.
Instead, the EPA recommends opening a window, closing off the room, shutting off forced air heat or cooling and allowing about 15 minutes for the mercury vapor to dissipate.
Golia, mercury vapor light (1 female); FL: Palm Beach Co., Delray Beach, Country Lake (on Military Trail), Feb.
A 200 watt/inch medium pressure mercury vapor lamp or equivalent UV light source is recommended.
The section on health assessment discusses health effects caused by mercury vapor and methylmercury, guidelines and reference doses, sampling fish for health assessment, the medical exam, and public information.
The Food and Drug Administration has issued a warning to alert schools and other indoor, all-purpose facilities about the potential dangers of high-intensity metal halide and mercury vapor lighting.
Typically, fluorescent lamps consist of a sealed glass tube coated with a powdered phosphor material and filled at low pressure with argon gas and mercury vapor. Tungsten coils coated with an electron-emitting material form electrodes at either end, and when voltage is applied, electrons pass through the tube, striking the argon atoms and releasing more electrons.