Rawl plug


Also found in: Dictionary, Thesaurus.

Rawl plug

A proprietary name for a concrete insert.
References in periodicals archive ?
TOOLS AND MATERIALS : 18v cordless hammer action drill Spirit level Tape measure Pencil Screws Rawl plugs Two lengths of spliced baton Top Tip: With an object of this weight and size, I recommend only fitting it to a solid wall - a partition wall will not be strong enough.
Tap your rawl plug into the hole you have already drilled until it is flush with the front of the timber batten, place a suitable size screw into the rawlplug - Gary used a 4 inch screw - and turn a few times.
DONNY'S LITTLE HELPER Solid walls must be drilled into with a masonry drill bit and the size of the bit must match the size of the wall plug - or rawl plug. RUSTINS treating decking use Rustins which cleans decking, weathered that green droppings.
Again this should come with a screw and a 5mm rawl plug. Drill a small 5mm hole into the plasterwork and apply the plug until it's flush to the surface, then drive your screw in, leaving it proud of the wall by about 5mm.
All the holes will line up, allowing the screw to pass into both the hole in the plywood and into the Rawl plug in the brick roof.
It is a disc which you moisten, wrap around a new rawl plug and insert back into the offending hole.
1For fixing a hanging basket to a wall, use a Rawl plug. Its size will depend on the screw needed.
Milne may have made a personal fortune in the building trade but someone really needs to take him aside and remind him how to insert a rawl plug.
aluminium/ gi supports of size not less than 60mmx60mmx0.5mm at the back of hanging, on ss screws fixed to wall with rawl plugs etc.
Before the waterworks begin, assemble the following: Waterproof sheeting Spanner Screwdriver Drill Tape measure Spirit level Roll of PTFE tape Corrosion Inhibitor (speak to your supplier about this) 2 radiator valves Rawl plugs Brand new radiator 2 TURN OFF THE TAP Start by switching off your boiler at the source, then find the 'isolation point' - most likely a stopcock that, when closed, should block any new water from entering your heating system during the process.
Once you're happy with the height and width of your diagram, use your spirit level to check proposed bracket locations are absolutely level, and drill holes in appropriate locations for Rawl plugs. Then attach your brackets and, from them, hang your radiator.