Transformer, Current

The following article is from The Great Soviet Encyclopedia (1979). It might be outdated or ideologically biased.

Transformer, Current

 

an instrument transformer for the measurement and monitoring of large currents by means of standard measuring instruments and automatic control and monitoring devices. It also serves to insulate apparatus from the potential of the circuit that is being measured or monitored. A distinction is made between AC transformers (usually known simply as current transformers) and DC transformers.

The primary winding of an AC current transformer (seeINSTRUMENT TRANSFORMER, Figure 2) consists of one or several turns of wire w1 of relatively large cross section; it is connected in series with the circuit whose current is to be measured or monitored. The secondary winding consists of a large number of turns of wire w2 of comparatively small cross section; instruments having negligible internal resistance—for example, ammeters, meters, and relays—are connected to it.

The distinguishing feature of a current transformer is that the current I1 in the primary winding is independent of the operating conditions of the secondary (in practical terms, the secondary winding is short-circuited). The primary magnetomotive force I1w1 is balanced by the magnetomotive force I0w1 (which gives rise to the main magnetic flux in the core) and by the magnetomotive force I2w2, which determines the demagnetizing effect of the current I2. Under normal operating conditions, I0w1 is usually 1–3 percent of I1w1—that is, I1w1I2w2. If the transformation ratio is known, this relationship makes it possible to determine the large current I0 by measuring the relatively small current I2. Since, nevertheless, I0w1 is nonzero, the measured value of I1 has a current error determined by the relative value of I0w1 and an angular error determined by the phase shift between the currents I0 and I2. In some transformers, called compensated current transformers, the measurement errors are canceled out. The rated value of the current I2 in most current transformers is 5 amperes. Since current transformers are used in circuits where short-circuit currents may occur, the windings of such transformers are also required to withstand short-duration currents that substantially exceed the rated values.

Current transformers are made for various purposes; types distinguished on this basis include instrument, protective, line, and laboratory transformers. Transformers may be of the outdoor or indoor type, or they may be built into electrical apparatus and machines or attached in various ways, such as by means of a bushing; they may also be portable. Other bases for distinguishing various types of transformers include the number of stages (single-stage or multistage), the method of attachment (through-type, including hook-on meters and pole transformers), the number of turns in the primary winding (single-turn, or rod, and multiturn), the operating voltage (low-voltage or high-voltage), and the type of insulation on the windings (dry, resin-paper laminate, and poured insulation). (For DC current transformers, see.)

REFERENCES

Bachurin.N. I. Transformatory toka. Moscow, 1964.
Elektricheskie izmereniia: Obshchii kurs, 4th ed. Edited by A. F. Fremke. Leningrad, 1973.

M. I. OZEROV

The Great Soviet Encyclopedia, 3rd Edition (1970-1979). © 2010 The Gale Group, Inc. All rights reserved.
References in periodicals archive ?
They should, therefore, be looked for every time a test is carried out; incorrect polarity in the current transformer, current transformer installed in wrong direction, current transformer circuit not grounded, additional unintentional ground connections and malfunction of a relay test plug or relay test connector.
With the decreasing secondary circuit load of current transformer, current errors are decreasing and for different magnetic circuits are not equal (Fig.
3) within a transformer, currents are mutually phase shifted by 180[degrees], thus value of directional index is equal to -1 pu.

Full browser ?