Wood Seasoning

Wood Seasoning


the process of inducing evaporation of the moisture contained in wood; a type of hydrothermic treatment of wood.

The purpose of seasoning is to reduce the moisture content in the wood to a level appropriate to the use of the articles made from the wood. This prevents changes in the dimensions and shape of the articles, eliminates wood rot, increases the strength of the wood, reduces the weight of the articles, strengthens glued joints, and improves the quality of finishing. Wood is seasoned in various forms: lumber, peeled or planed veneers, crushed wood particles, and semifinished articles.

The simplest method of seasoning lumber is open-air seasoning, in which the lumber is stacked in the open air or under canopies for a period of two or three weeks to several months. The principal industrial method, kiln drying, uses kilns fed with hot air, a mixture of air and fuel gases, or superheated steam. Kilns with steam are the most commonly used type. Continuously operating kilns are used primarily for large-scale seasoning of lumber prior to shipping; moisture content is reduced to 18–22 percent. Batch kilns are used to season wood to a moisture content of 7–10 percent.

The reduction of moisture content causes irregular drying of the wood, and internal stresses arise that may cause cracks to form. In order to prevent this, the relative humidity of the drying agent is lowered and the temperature is raised in the course of the seasoning process. Conditions for kiln drying lumber are standardized in the USSR. Depending on the desired intensity of the process and the later use of the wood, the following regimes are used: mild (temperature at the start of seasoning is 40°–50°C), normal (60°–80°C), accelerated (80°–100°C), and high-temperature (over 100°C). The length of the process varies from 15–25 days (mild regimes for hard woods) to 20–30 hr (high-temperature regimes for soft woods). If the wood is to be precision machined, it is steam-treated after seasoning to remove internal stresses. Seasoning in a high-frequency electric field is also used (seeDIELECTRIC HEATING).

Continuously operating roller driers are ordinarily used for peeled and planed veneer. The sheets of veneer are surrounded by hot air (110°–130°C) or fuel gas (150°–250°C) and are moved through the drier on roller conveyors. The process lasts two to 12 minutes. Presses in which the plates are periodically opened and closed may also be used to season veneer. The temperature of the plates is 130°–170°C, and the process lasts up to two minutes. A promising method for the future is the processing of peeled veneer in a continuous ribbon, rather than in sheets, in driers with forced ventilation through nozzles and metal belt or roller-chain conveyors.

Crushed wood particles for chipboard are seasoned primarily in gas drum driers at temperatures up to 500°C. Pneumatic units in which the particles are seasoned while suspended in a gas stream are also used. For packing chips and small semifinished articles, such as matchsticks, belt driers are used in which heated air is circulated around a layer of material on a mesh belt.


Krechetov, I. V. Sushka drevesiny. Moscow, 1972.
Sergovskii, P. S. Gidrotermicheskaia obrabotka i konservirovanie drevesiny. Moscow, 1975.


References in periodicals archive ?
Tenders are invited for Supply, Installation And Commissioning Of Steam Operated Wood Seasoning Plant Having 3 (Three) Kiln Chambers Along With A Boiler Compatible / Suitable For Operating Such Plant At A Time
Similarly, work on setting up of a Furniture Village at Jalozai is in progress while Wood Seasoning Plant for Dir and Peshawar has been approved.
Courses titled Wood Anatomy and Identification, Properties of Wood, Lumber Manufacturing and Distribution, and Wood Seasoning and Preservation were offered in the early 1960s.