area ratio


Also found in: Acronyms.

area ratio

The ratio of the area and the square of span of an airfoil. It is the opposite of aspect ratio.
References in periodicals archive ?
Caption: FIGURE 27: Schematic diagram of uplifted nodes under Songpan wave for HV case (54 nodes uplifted and uplift area ratio is 25.6%).
Crop growth indices such as leaf area index (LAI), net assimilation rate (NAR), relative growth rate (RGR) and leaf area ratio (LAR) are important traits in crop physiology.
Comparing the three service control strategies which use different spectrum allocation scheme, we find that using shared subchannel allocation scheme in AmBD strategy can obtain maximal EE when area ratio is very small.
For statistical analysis, a T-test was done for the average comparison of treatment area ratio of the area before and after the tumor treatment and it was analyzed by correlation coefficient.
Development of Biotope area ratio standardization Estimation model using GIS.
"Increase in floor area ratio translates into higher supply of real estate in any area -- this is particularly good for Delhi as there has been no expansion in residential master plan for more than two decades now," said Nishant Singhal, Director of Strategy and International Operations at Investors Clinic.
Fine-pitch printing results are directly tied to stencil aperture area ratio, a relationship between aperture area and stencil thickness.
The predictive powers of the vertical C/D ratio and C/D area ratio (obtained by 3D optic disc photography) were 0.842 and 0.832, respectively, revealing the overall high predictability of these parameters.
For the diffuse radiation transmitted through the windows and direct reflected solar gains, three methods are considered: area ratio, absorptance weighted area ratio, and radiosity.
45 for area ratio 2, whereas for area ratio 0, it is at y/Ym =0.41.
The lot allows for a floor area ratio of 15, plus some additional air rights acquired by the seller.
In order to increase iron chill effectiveness, its contact surface must be relatively large with a volume-to-contact area ratio of 1:1.