bed surface

bed surface

Of a brick, the in situ non-vertical surface intended to be joined by mortar.
References in periodicals archive ?
With the participant lying on their back, the thighs and calves completely supported by the bed surface, the locating point was defined as the most protruding point located 5-10 cm up the thigh from the top of the knee cap.
The company sells more than 40 types and styles of wood that can be installed without drilling into the bed surface. Bed Wood and Parts can also furnish wood flooring for van and sport utility vehicles.
I have been thinking of creating a new tilting mattress platform that can raise a few degrees on one side to create a flat bed surface when parked on the side of the street that has a slope to it.
Two NIWE staff will also participate in the survey campaign, which will provide data on sea depth, soil, sea bed surface and objects found in the soil.
The domes are mainly hemispherical, ranging from 0.8 cm to 2 cm in diameter and project up to 0.5-1 cm from bed surface. Distribution of the domes on the bed top is very irregular and some trace fossils (Planolites-type) are also present among and cross-cutting them.
(2011), the application of wastewater to the subsurface maximizes the use of the cross-sectional area of the HSF-CWs, reducing the preferential accumulation of solids on the bed surface. The studies of Chazarenc, Maltais-Landry, Troesch, Comeau, and Brisson (2007) and Knowles, Griffin, and Davies (2010) showed that, in both configurations of subsurface and surface inlet of the influent, there may occur the formation of SF due to the clogging.
Here, [C.sub.t] is the volumetric concentration of total-load sediment dimensionless, [[rho].sub.0] is density of the water and sediment mixture in the bed surface layer, determined by [[rho].sub.0] = [[rho].sub.s](1 - p') + [[rho].sub.w]p', p' is the porosity of the bed material, and [[rho].sub.w] and [[rho].sub.s] are water and sediment densities.
Wider bed surface options are currently available with little cost increase over available traditional beds.
To prevent load slippage, a non-skid frame bed surface is included, while a textured, powder-coat finish protects against damage.
Process cases Influence factors U P F S [P.sub.1] Cast iron 7 Surface scratch Bed surface [P.sub.2] Cast iron 6 Rail wear Bed surface [P.sub.3] Cast iron 7 Rail wear Bed surface [P.sub.4] Cast iron 6 Surface crack Bed surface [P.sub.w] Cast iron 7 Rail corrosion Bed surface Process cases Influence factors D H L V R [P.sub.1] Moderate No 0.013 60 320 [P.sub.2] Slight No 0.012 45 320 [P.sub.3] Slight Quench 0.010 55 300 [P.sub.4] Slight No 0.011 60 320 [P.sub.w] Moderate No 0.012 55 300 TABLE 5: The detailed information of case P2.
Aeolian sand ripple is one of the most common sand morphology in the desert and formed on the sand bed surface by moving sand particles.
(1) The existence of submerged plants increases the flow gradient, and the roughness of the bed surface becomes larger, which plays the role of spoiler, and with increasing plant density is more obvious.