bending load

bending load

A load that tends to bend the member under the load.
References in periodicals archive ?
The load arms of bending moments that femurs must resist are in proportion to the femoral length, whereas the bending load is in proportion to body mass (Selker & Carter; Habib & Ruff, 2008).
where b is the beam width, d is the beam depth, [DELTA]P/[DELTA][delta] is defined as a relationship between the slope of the elastic region for the load P--deflection [delta], and [P.sub.bmax] is the maximum bending load.
Because the bird impact samples under bending load did not break completely, X-ray 3D microscopy (diondo D5 type high-resolution X-rays system and service) imaging was adopted to observe the material internal structural damage for bird impact damage characterization.
Besides, limited work has been performed on chloride transport property of SFRC under bending load. The study on prediction of chloride ingress in SFRC under load is also scarce.
Requirement for the normalized bending load. In the catalogs for pin insulators [??][PHI]-10-20 kV and [??]C-10-20 kV, the normalized mechanical force for bending [F.sub.bend] = 12.5 kN is indicated.
In the Ozone Dynamic Test, the hose is subjected to a cyclic bending load in a controlled ozone atmosphere.
Results in figures 2 and 3 shows that the bending load is 1.18KN when pulse on time is considered to be 50%, peak current is 160A and base current is 50 to 60A with 10Hz and 2Hz pulse frequency.
(2015) Infrared thermography to evaluate thermoplastic composites under bending load, In: Composite Structures, Vol.
So we give the critical buckling stress of web under bending load and under shear load based on [15].
For this type of vehicles, the influence of the upper body on the bending load generated in the lower limb is compensated by setting the impact height of the FlexPLI 50 mm above that of pedestrians.
The total stress due to internal pressure and axial bending load can then be compared to the estimated axial failure stress.