blade radius

blade radius

blade radius
The radius of the circle described by the tip of a rotating blade (i.e., the distance from the blade tip to the axis of rotation).
References in periodicals archive ?
Up to two (2) types will be installed in the ca, - no change in the location of the a / c of the ca is allowed, Which is delineated on maps and topographical diagrams included in issue 5, - the maximum cumulative height of the tower (pylon) and the blade radius of the offered a / c may not exceed one hundred and fifty (150) meters, - the distance between the a / c of the cw shall not be less than two and a half (2.5) times the diameter of the wings of the a / c, - the offered a / c must be a horizontal axis, With three blades, A steel-toothed-toothed tower and access to the wagon~s shaft only internally from its tower, - the average annual availability of the ca guarante
The far-field boundary is stretched up to 5R (blade radius), centered at the rotor hub.
Blade pitch was set to zero-degree collective at 75% blade radius. The performance of each configuration was predicted at the design operating conditions, and with no base motion.
Where is the air density [kg/m3], r is the blade radius of wind turbine, V is the wind speed.
Refused: | Installation of an Endurance E-3120 24.8m nacelle height, 9.6m blade radius (50kW) wind turbine, Land West of Marsden Gate, Sowood, Elland.
In the optimization process, airfoils are taken from the aerodynamic database; design is optimized to give the best power output for given number of blades, blade radius, wind speed and rotational speed.
TAB-Stay features a 38-mm wide blade with a 20-mm blade radius, which allows up to 40-mm depth tissue retraction.
The granulation end-point calculator can calculate net impeller power for various wet mass conditions using viscosity, fill ratio, mixer speed, blade radius, or Newton, froude or reynolds dimensionless numbers; recalculate Newton power number, given net impeller power, impeller speed, blade radius, and wet mass density.
The flip tip consists of a hinge at approximately 95% of the helicopter blade radius. During descent or other high-noise maneuvers, the tip of the rotor can "flip" up or down to adjust the wake location relative to the blade path.
The maximum cumulative height of the tower and the blade radius of the offered A / C can not exceed the licensed, ie it must be equal to or less than 77 meters.