board insulation

board insulation, insulating board, insulation board

Rigid or semirigid thermal insulation having a thickness small in comparison to other dimensions; density usually about 4 to 16 lb per cu ft (64 to 256 kg per cu m); low structural strength.
McGraw-Hill Dictionary of Architecture and Construction. Copyright © 2003 by McGraw-Hill Companies, Inc.
References in periodicals archive ?
Rigid foam board insulation: These are rigid pieces of insulation that are cut into board shapes or, in some cases, molded into the shape needed.
suggested we use an integrated framing system metal Z-frame with foam board insulation that attaches directly to the concrete walls.
DOW Thermax polyisocyanurate rigid board insulation. Each panel is built with 5,000+ psi concrete.
In a reverberatory furnace, extra castable insulation in the roof and block and board insulation in the upper sidewalls roof was added.
The key is the ratio of the thermal resistance of the rigid board insulation to the cavity insulation.
The control duct consists of a traditional installation of buried PVC-coated spiral sheet metal air duct surrounded on four sides with R-10 (ASTM C518) board insulation. The temperature of air flowing through the test and control ducts is measured and compared.
Then the hunters added foam board insulation panels all the way around the container and covered the insulation with white sheet-metal barn siding, attached with self-tapping screws.
I use foil-faced board insulation, which I wrap around the filters (mine are round) by cutting through one side of the foil but not the other to make it fit around a curved surface, and then gluing it to the filter itself.
Dear Henri: In a recent column, a question was asked by a Michigan reader about how to fasten foam board insulation to a brick wall on the porch, among other concerns.
The second is a new line of its Gulf-O-Glue range with a lower level of volatile organic content (VOC) than its standard range, which is used to bond foam board insulation. This is being produced to meet specification requirements from a growing range of consultants who have to meet greener environmental standards, Mohn added.
The foam board adhesive is a premium-grade formulation for bonding foam board insulation to a variety of surfaces.
[3] According to RS MEANS Building Construction Cost Data 2011; the cheapest combination of rigid board insulation thickness was assumed for the cost analysis (e.g., 22.9 cm or 9 in.