board sheathing

board sheathing

board sheathing
A sheathing of board, usually tightly spaced, but some roof constructions use open spacing between boards.
References in periodicals archive ?
The siding is nailed directly to oriented strand board sheathing. There is no Tyvek house wrap or tar paper but the joints in the sheathing have been heavily caulked, so the house has been fairly tight with little air infiltration.
Board sheathing, asphalt impregnated felt building paper.
Compared to the ultimate strength for the same type of specimens, the wall frame with gypsum board sheathing had the greatest value, the wall frame with calcium silicate board had the secondary value, and the wall frame with gypsum boards had the smallest value.
* expanded polystyrene h]) plus 0.09 m (3.54 in.) polyurethane - Concrete slab, d = 0.12 m (4.72 in.) From inside to outside: - Gypsum wallboard internal lining Facade - Joint taped oriented strand board sheathing, d = 0.015 m (0.59 in.), acting as an air barrier (Figure 2) U = 0.13 - 0.3 m (11.8 in.) of W/([m.sup.2] * cellulose fiber K) filling the bays between the engineered timber (0.023 - Vapor permeable Btu/[[ft.sup.2] wood fiber board * [degrees]F.
Manufactured by US-based modular construction specialist Novi Industries, the sustainable, pre-fabricated modular bathroom pods are built using environmentally friendly materials such as light-gauge steel framing and magnesium-oxide board sheathing. These major structural components containing non-toxic materials are known for advantages such as fire proofing, resistance to water infiltration, pests, mould and mildew as well as seismic activities.
The effect of over-driven nail heads on single shear connections with oriented strand board sheathing. Tech.
The builder installed a popular type of rigid foam board sheathing directly over the wood frame, followed by vinyl siding.
Mark rafter locations every 16 inches for plywood sheathing or corrugated roofing and every 24 inches for inch-thick board sheathing. Make all rafters identical and fabricate them into identical trusses.
After gypsum board sheathing was attached to light-gauge structural steel framing, EPS board was attached and covered with the base and finish coatings.
* Oriented strand board sheathing for roof and walls
Also note the cornerbead installed "backward" (8) to support the gypsum board sheathing on the interior of the fire wall framing.