The progression of photos on this page illustrate how the faux butt hinge
works: (1) the cabinet without the butt hinge
; (2) the cabinet interior showing the concealed hinge; (3) peeling the protective cover off the EuroButt II hinge; (4) applying the EuroButt II hinge against the door face; (5) pressing the EuroButt IIPSDA tape into place; (6) setting the nail; (7) the EuroButt II with the nail set into the countersunk hole; (8) the EuroButt II hinge is in place and the door is installed with the concealed hinge; (9) a view from the outside, with the partially opened door; (10) the EuroButt II hinge with the door fully closed.
6 x 5/8" hex head screws 4 Bolt retch 1 3-1/2" x 3-1/2' door butt hinges
3 2" x 3" hinges 1 pr.
Or, to save money, choose heavily galvanized door-style butt hinges
that must be inset a fraction of an inch into the wood of the gate post.
You'll also need eight 1/2-by 2-inch mending plates (shown below); nine 1 1/2-inch brass butt hinges
, available at hardware stores; and a drill, a screwdriver, craft glue or a glue gun, sharp pruning shears, two semitransparent wood stains, acrylic-base satin-finish varnish, and highlight paint (optional).
FDB's Rocfast service covers all products encompassed in their profile - this includes: budget locks, camlocks, compression locks, knob locks, rod locks, spanner locks, waterproof locks, toggle latches, concealed hinges, flush hinges, butt hinges
, lift-off hinges, 'piano' hinges, stainless hinges, weld-on hinges, earth bars/busbars, flush handles, grab handles, lever handles, tee handles, paddle handles, padlocks, support stays and seals/gaskets.
Cut the seat an inch wider than the box base, and fit using 2 inch butt hinges
6 sheets 3/4-inch plywood 4 6-foot-long 2-by-2s 24 T-nuts for 3/8-inch bolts 24 21/4-inch machine bolts 2 butt hinges
for door 1 1/4-inch woodscrews 2-inch finishing nails Wood glue
Mount the doors with four butt hinges
, and install latches and handles, and if desired, pneumatic door closers.
Two 2-inch butt hinges
under the top's front (or bottom) lip allow it to tilt up.
If you use standard butt hinges
, you can mortise (chisel out) spaces for them or surface-mount them on the backside as shown in Figs.
Movable rail and walkway sections are attached with heavy butt hinges
and fastened in place with sturdy hooks and eyes.
Made of redwood 2-by-2s, the heavy lid pivots on brass butt hinges
mounted along the rear lip.