cap molding

cap molding

Trim at the top of a window or door; above the casing trim. See also: Molding

cap molding, cap trim

1.Molding or trim which embellishes the top of a dado.
2. Molding, at the head of a window or door, above the simple trim of the casing.
Mentioned in ?
References in periodicals archive ?
* High-speed cap molding: Engel is showing off the capabilities of its all-electric e-cap system with a 460-ton model molding 26-mm HDPE beverage caps with tamper-proof bands in a 96-cavity mold on a 2-sec cycle.
The wainscoting fit nicety into a groove in the base and then was held at the top by a grooved cap molding. To help secure the wainscoting, I'd angle a nail from my nail gun at intervals to hold the pieces while the glue dried.
During that time, considerable knowledge has been gained in the types of systems most often used in the filtration industry for applications such as end cap molding, end cap sealing, HEPA frame sealing and filter gasketing.
Figure B shows an example of a cap molding for a head casing that we made by stacking two pieces of 3/4-in.
has introduced its Servo-Flo 608 meter system designed to meter mix and dispense two-component materials for high speed filter end cap molding applications.
* Cap molding: Ferromatik Milacron will have three cap-molding demonstrations, including one cell for two-component barrier closures.
4' x 8' x 3/4" birch plywood 1 2-1/4"-wide crown molding 5 3/4"-tall base cap molding 5 1-1/4" screws 1 box 1-5/8" screws 1 box 3/8" dowels 16 1-1/2" finish nails 1 box Hinges * 4 Shelf supports 8 Spray primer 1 can Spray paint 2 cans Wood glue Wood filler * To order hinges, call (800) 383-0130 or go to www.wwhardware.com.
Ashby Cross Company will display several types of casting machines for filter end cap molding. Based upon precision gear metering pumps, the systems can handle a wide range of urethane and epoxy materials.
The base is simply a plywood platform covered on three sides with mitered baseboard and base cap molding (Figure A), Assemble the platform parts with brad nails and then add 2-in.
You'll also notice in Photo 16 that the cap molding protrudes a bit and needs to be rounded where it meets the window or door trim.
13 GLUE the upper apron assembly to the sides after nailing the divider cap molding to the top of the casing.
You may not find the same base cap molding (55 [cts.] per foot) we used to frame the Environ and panels (Photo 15), but very similar profiles are widely available.