circular mill

circular mill

The area of a circle having a diameter of 1 mil (1/1,000 in.); used in specifying wire size; equals an area of 0.00051 sq mm.
Mentioned in ?
References in periodicals archive ?
Voith's circular mill is equipped with an incremental drive and can be setup for the machining of large internal diameters and flanges.
A log so flattened was called a "stock" and was then cut into boards or planks on a standard gang or circular mill.
Maddy explained: "One of the punishments was a treadmill, a circular mill wheel for grinding.
The three-mile circular mill walk, which starts at the Midgehole car park, takes about two hours, and goes past Slurring Rock with magnificent views before following the track from the main entrance to Gibson Mill and into the wet and wild woodland.
So Heller decided to circular mill the bottom of the face and then finish bore it to achieve the tight tolerances.
The circular mill building itself has been transformed into a mill room on the ground floor, large bedroom on the first floor and bathroom on the top floor.
The board foot yield from a typical bandsaw mill will be greater than that of a typical circular mill. Bandsaws result in less sawdust and more lumber due to a smaller kerf.
THE three-mile circular Mill Walk, starts at the Midgehole car park near Hebdon Bridge and takes around two hours, following the track from the main entrance to Gibson Mill where youOll be able to find out more about its 200-year history.
For instance, its 1.108-inch-diameter, or Drake, cable has an aluminum area of 1,020,000 circular mills, or 1,020 kcmil, compared with 795 kcmil in a steel-reinforced cable of the same diameter.
THE restored windmill at Whitburn Village and the remains of the Cleadon Mill are included in an eight-mile circular Mills Walk being held on Sunday September 12 setting off at 10am from Whitburn Bents Road.

Full browser ?