depth curve


Also found in: Dictionary.

depth curve

[′depth ‚kərv]
(oceanography)
Mentioned in ?
References in periodicals archive ?
(2) The carbonation depth curves obtained from the finite element method are consistent with the experimental results and the practical measuring value in engineering.
Caption: Figure 10: Carbonation depth curves: (a) C25 concrete (w/c = 0.65); (b) C30 concrete (w/c = 0.55); (c) C35 concrete (w/c = 0.45).
This result suggests that the revised force-penetration depth curve contributes to a more accurate Young's modulus.
After the force-penetration depth curves were obtained, Young's modulus of the Ti[O.sub.2] microspheres with various radii was calculated via (3) as shown in Figure 4(b).
Loading force at 500 mN was applied in a progressively increasing in 15 seconds; following indices were determined: Martens hardness (HM), Martens hardness from the slope of the increasing force/indentation depth curve (HMs), indentation hardness (HIT), elastic intentation modulus ([E.sub.IT]), indentation creep ([C.sub.IT]), elastic ([[eta].sub.IT]) and plastic ([[eta].sub.plast]) parts of the indentation work.
Figure 9 displays the penetration rate and penetration depth curves of piles in series J and series L, and it is found that the curves in Figure 9(b) are lightly messier than those in Figure 9(a).
Average lateral deflection Vs Depth curves, average bending moment Vs depth curves for each row in pile group were obtained.
6; Tables 7, 8), and slope (Tables 7, 8) computed from the penetration depth curves were used in this study to discuss quantitative scratch resistance ("Penetration and residual depth: experimental curves analysis" and "Slope, penetration, and residual depth: statistical comparisons" sections) of the different types of multilayer coatings (MCs, as shown in Table 5) on wood surfaces.
It is worth to mention that the apparent dependence of elastic modulus on penetration depth is much likely an artifact arising from the fitting of contact radius versus penetration depth curves introducing an apparent dependence on penetration depth, because a considerable dependence is shown also by the thick film (black series) at low penetration depth, which is certainly not due to substrate effect.
Lake depth curves for the Deep, Shallow, and Ice Runs are shown, but we consider only the Ice Run curve.
The slopes of the force-penetration depth curves were extracted in the penetration depth range of 0.3-0.4 mm and reported in Fig.
Figure 3 shows the load versus penetration depth curves for the three indented materials performed with spherical tip.