entrance angle

[′en·trəns ‚aŋ·gəl]

(engineering)

In molding, the maximum angle, measured from the center line of the mandrel, at which molten material enters the land area of a die.

References in periodicals archive ?

Instructions/Remarks: Retro Reflective Sheet Ultra Light High Intensity Grade Golden Yellow With Minimum Coefficient Of Retro Reflection, Coefficient Per Feet 2 Degree Observation And 4 Degree Entrance Angle.

Retro Reflective Sheet Golden Yellow Colour Ultra Light High Intensity With Seven Year Warranty Certificate Alongwith Supply Make: 3m, Nikkilite, Scotlite In Roll Of 4 X50 As Per Enclosed Specification

entrance angle and length of outlet land) of the conical dies were used to prepare and investigate the ultra-drawing properties of the UHMWPE as-prepared fiber specimens.

Ultrahigh molecular weight polyethylene fibers prepared using conical dies with varying dimensions

i]--the entrance angle of the oil into the piston chamber,

Coanda effect in oil flow through hydraulic command resistances

The entrance angle of the drill string should be between 8 [degrees] and 18 [degrees] with 12 [degrees] being optimal.

Guidelines for installing PE gas pipes using HDD

50 mm) ratio was 20 with an entrance angle of 45[degrees] and 60[degrees] (compound).

Thermoplastic elastomer based on ionomer

2 Entrance Angle In Degree Ea :-4 Yellow:50 Observation Angle In Degree Oa :0.

Luminious strip yellow reflective sheeting yellow techanical specification:1.Grade:-engineer 5 grade reflective sheeting 2. durability: 5 years. 3. standard size:62cmx45.7 mtr. 4. feature and applicat

The effect is mitigated by decreasing the entrance angle simply because of a decrease in the average Hencky strain rate in the entry region of the die.

Melt fracture of two broad molecular weight distribution high-density polyethylenes

2, Entrance Angle In Degree Ea : -4, Yellow: 50, Observation Angle In Degree Oa : 0.

Luminous strip yellow reflective sheeting yellow , tech specification: grade:engineer 5 grade reflective sheeting , 2. durability : 5 years. 3. standard size: 62cmx45.7 mtr.4. feature and application:

23, and entrance angle of 26[degrees] at shear rate of 810 [s.

Phase morphology development in a low interfacial tension immiscible polyolefin blend during die extrusion and melt spinning

2, Entrance Angle In Degree Ea :-4, White: 70, Observation Angle In Degree Oa : 0.

Luminous strip white reflective sheeting white , grade: engineer 5 grade reflective sheeting , 2. durability: 5 years.3. standard size: 62cm.X45.7mtr. 4. feature and application: standard sheeting for

0 mm, entrance angle of 180[degrees], and L/D ratios from 10 to 30 were used.

The synergistic effect of boron nitride particle and die on the capillary extrusion processability of mLDPE

Hence, the solutions for mitigating gross melt fracture are to reduce the entrance angle of converging dies (15-19) or to stack filters at the bottom of the reservoir, just before the contraction plane (20-22).

Gross melt fracture mitigation in converging dies: a singular behavior due to polymer wall slip

Full browser ?

CITE

Site: Follow: Share:

Open / Close