In fact, in (4) the weight of the submerged part of the sliding wedge is considered through the effective unit weight of soil which is reflected in the force equilibrium diagram
, and then [K.sub.a] is calculated.
In constructing any phase diagram, whether oxide or alloy, it is necessary to answer the following questions: (1) What are the most effective ways of preparing the diagram/library, (2) What are the best techniques to analyze the compositions so as to ascertain the phases present and construct the tie-line relationships, (3) How can it be determined whether the result represents equilibrium at the given conditions; how well does it match the equilibrium diagram prepared using bulk methods; how does it compare with the calculated diagram; (4) How well does the library reproduce the relevant properties of the bulk materials; (5) How can the property information collected for the library be rapidly assessed.
The equilibrium diagram of the system Mo-Co was reported by Quinn and Hume-Rothery (14) (Fig.
The partial pressure [p.sub.i] is related to the mole fraction [x.sub.i], of constituent i in the liquid phase (through the vapor pressure equilibrium diagram of the mixture), which is defined as:
To better understand this behavior and specifically the comparatively large observed ethanol intake, the vapor-liquid equilibrium diagram of the ethanol/toluene/isooctane ternary blend has to be established and the equilibrium in the presence of various ethanol-hydrocarbons mixtures with variable concentrations and activities should be studied quantitatively.
The equilibrium in the system of LiCl[O.sub.4]-NACl-[H.sub.2]O is shown in the equilibrium diagram in Figure 1 based on the facts on solubility given in Table 1.
Therefore, depending on the concentration of sodium perchlorate that can be achieved in the process of electrolysis (600-1000 g/l NaCl[O.sub.4]), different concentrations of LiCl[O.sub.4] and NaCl can be obtained; however they always lie on the 0-X vector of the equilibrium diagram, Figure 2.
As regards the second depressant (silicon), according to the Ni-Si equilibrium diagram
, the maximum solubility of silicon in nickel is 15.8 at.% at a temperature of 1143[degrees]C (4).
Analysis by electron microscopy indicates the formation of Mg2Si compound being under conformity with ternary equilibrium diagram
Al-Si-Mg, which leads to micro-porosity in adjacent areas of the compound.
He explains that his 2002 book sold well, but the equilibrium diagram
it contained did not, so he finds it necessary to work out numerically, and fully for the first time, the maximum yield of the equilibrium diagram
electrochemical processes, namely the fuel chemical exergy.
The numerical value of the liquation coefficient can be determined on the basis of the equilibrium diagram
. Depending on the type of phase diagram, the value of [k.sub.0] may be regarded as constant in a specific range.