filled composite


Also found in: Medical.

filled composite

[¦fild kəm′päz·ət]
(materials)
Mixture (composite) of thermoplastic or thermosetting resin and granular or short-strand fiber fill.
References in periodicals archive ?
Cylinders of nano- filled composite restorative (Filtek Z350, 3M ESPE, St.
Place a filled composite resin in the deepest area of etch channel.
In the case of NCC-talc hybrid filled composites, the highest impact strength was obtained at 10 wt% talc filled composites.
In fact, interparticle gap in composite with higher Pani content is less than that in composite with lower Pani loading and possibility of particle rearrangement due to movement of polymer chain is also less in highly filled composites. In composites with lower loading there is availability of more number of free polymer chains (for lower filled composite) those are unrestricted and unlinked with the filler aggregates, and hence takes more time to be relaxed.
Figure 4 shows anisotropic properties of CNT(B) filled composites. In fact, for systems filled with CNT(B), the modulus is higher in IP configuration than in TT configuration.
As shown in Figure 3, compared with neat HDPE, HDPE, and HDPE/RHDPE, PB dust filled composites had lower melting peak temperatures, higher crystallization peak temperatures, much lower crystallization rates at crystallization peak temperatures, and wider crystalline temperature range, which implies an improvement on the processing temperature of composite.
(3) the mechanical properties of fiber filled composites have a certain effect on the mechanical properties of the composites.
pe dielectric properties of unfilled and filled composites of epoxy resins have been studied as a function of pickness in pe frequency range 10-1 Hz to 105 Hz at room temperature.
After compounding, the unmodified and modified zeolite filled composites were compression molded into 1mm of sample thickness.
While the increasing filler loading had increased the water uptake and swelling, the maximum percentage of weight gained was obtained by 50 % of 63 [micro]m dolomites filled composites. Based on the trend, we can say that the smaller the filler sizes, the higher the water absorption percentages.
This study is about how the filler's dispersion into the matrix is influencing the basic properties of filled composites. In the case of moulded thermosetting based composites three ways to disperse the powders into the matrix are available leading, probably, to different final properties.
Minimal thickness is observed in least filled composites of the I group h = 122[+ or -]2.4 [micro]m (number of measurements n = 5) and maximal thickness-in the most filled composites of the III group h= 187[+ or -]3.74 [micro]m (n = 5), at that thickness of composites of the II group h = 146[+ or -]2.92 [micro]m (n = 5).