goose neck


Also found in: Dictionary.
Related to goose neck: Gooseneck State Park

goose neck

1. Any section of pipe, curved like the neck of a goose, or in a U-shape; sometimes flexible.
2. In ductwork, an inverted U-shaped duct section with a screened opening; used for air intake or exhaust.
3. A curved section of a handrail which forms its termination at the top of a newel post.
Mentioned in ?
References in periodicals archive ?
Tenders are invited for Pa Powered Podium Public Address System Specification - Mp-3 Compatible Usb/Sd Card Port With Recording Facility And Fm Player Built In Rms 60W Amplifier 60 Hms Out Put Buitl In Three 4 Woofer And One 2 Tweeter, Two Flexible Goose Neck Microphone And One Reading Lamp Mic-2 Line Input And Stereo Music Base, Tribble Aux, Mic-1 And Mic-2 One 4 Ohm And Two 8 Ohm Speaker Ac-220 Volt 50Hz.
Five tenders for the supply of (a) 9 volt batteries, 12 volt batteries & lithium batteries, (b) instruments to test distributors batteries, (c) connection clamps of 150/ 150, 70/ 150 & 70 / 70 type dual metal tie wire and end terminal, (d) goose neck shaped iron stand to fix on walls, also (e) rubber tires for vehicles and automotive equipment.
The featured tank fabricators on Buy American are able to custom fabricate all parts and accessories such as handrails, rolling ladders, platforms, bleeder vents, diffusers, chambers, roof stumps, vertical cage ladders, rafters, rolling ladders, quick draw stumps, spiral & radial staircases, pipe caps, leg sleeves, weirs, flanges, shafts, suction troughs, nozzles, emergency drains, funnels, gauge hatches, float wells, goose neck vents and other storage systems components and accessories," said Leary.
Four tenders for the supply of (a) goose neck shaped iron stands 4 inch / 19 mm size, (b) yellow Sterling branded insulating ribbons, (c) supply & erection of 400 / 525 volt, 300 KVAR, multistage capacitors boards for boilers & of similar but 550 LVAR with a safety circuit to protect from overloads due to incompatibility, also (d) lead accessories for 3 X 240 mm 2 cross section cables.
the required trailer is to be a goose neck trailer that is 24 ft long, 8 ft wide and 6 ft high.
Four tenders for the supply of (a) switchboards with 4 fuses, other with no fuses & a 12 KV transformer for use outside the building, (b) supply and erection of multistage 400/ 525 volt capacitors boards (300, 200, 350, 100, 150 & 250 KVAR) and of a 400/ 525 volt multistage capacitors board, 150 KVAR with related accessories, (c) goose neck shaped iron stands 3 inch / 19 mm size, also (d) transitional connection of 3 X 240 mm2 cross section, 11 KV.
Five tenders for the supply of (a) goose neck shaped iron stand with clips, (b) silica gel for the electricity distribution transformers, (c) different diameter galvanized and black iron pipes, (d) steel reinforced aluminum conductors of different cross section, also (e) instruments to remote measure temperature and other instruments to measure earth resistance.
Tenders are invited for Carryout miscellaneous shrouding, Rectification works of ss grating, Conducting dp test for the welded joints in pressure parts erection of temporary plat forms inside furnace just above goose neck, Erection, Shifting and dismantling of pneumatically operated sky climbers, High pressure jet cleaning of furnace water wall tubes, Opening of inlet coil seal boxes, Rectification seal trough plates, Providing of carbon steel square rods to s panel bends, Providing of clamps for coil tubes to hanger tubes and removal and re fixing of baffle plates for accessibility in ltr coils of unit-ii boiler during annual overhaul period for the year 2017-18.
Five tenders for the supply of (a) 500 KVA distribution transformers of low waste, (b) kiosks for 200 KVA distribution transformers, (c) low voltage aluminum cables, (d) goose neck shaped iron stands & (e) different capacity low voltage circuit breakers.
Tenders are invited for Carrying out miscellaneous shrouding, Rectification works of ss gratings, Conducting dp test for the welded joints in pressure parts, Erection of temporary plat form inside furnace just above the goose neck, Erection, Shifting and dismantling of pneumatically operated sky climbers, High jet cleaning of furnace water wall tubes, Opening of inlet coil seal boxes, Rectification seal trough plates, Providing carbon steel square rods to s panel bends, Providing of clamps for coil tubes to hanger tubes and removal and re fixing of baffle plates for accessibility in ltr coils of unit-i boiler during anuual overhual period for the year 2017-18