incident power

incident power

[′in·sə·dənt ¦pau̇·ər]
(electricity)
Product of the outgoing current and voltage, from a transmitter, traveling down a transmission line to the antenna.
References in periodicals archive ?
Parameters Laser Incident Power (W): 4.6 6.4 Irradiation Time (s): 30 30 Initial Tissue Temp.
Therefore, it is suggested that the incident power between 70 W and 80 W is selected as the laser recrystallization power of the [Si.sub.0.2][Ge.sub.0.8]/Si system.
According to the four-port MIMO antenna system, TARC is a parameter that refers to the coupling of the ports, and its value is between 0 and 1, where 0 means all incident power is radiated, but 1 means all incident power is reflected.
Measured, Mie, and CDA-predicted optically extinguished powers (E) were calculated as E = 1(1 - [10.sup.-A]), where A was 532 nm spectral extinction in absorbance units, based on measured, Mie, and CDA theory, respectively, and I was incident power of 532 nm irradiation (19-24 mW) for each AuNP-PDMS film.
Normalized by the incident power, the total coherent and incoherent scattering and transmission coefficients are obtained as follows, for TM polarization,
The results also show that the short-circuit current and open-circuit voltage saturate at high power density since the electric field is strong enough to separate any generated pair for a given incident power. For both cases the linear behavior of [V.sub.oc] versus incident power refers to good linearity of the prepared device to work as a detector or solar cell.
Radar backscatter [beta] is defined as the ratio of scattered power [P.sub.S] to the incident power [P.sub.I] [17].
First, an incident power is added into the proposed antenna.
Weak coupling can gain higher Q value, meanwhile, weak coupling also reduce the incident power. If we want to excite a field in the cavity, more incident power is needed for the weak coupling.
The increase of the thickness for RF power [less than or equal to] 80 W is primarily due to the increasing total incident power. That increases the ionization rate of the introduced Ar gas.
For the U9397C Switch, Figure 3 shows that the ON input reflection coefficient [GAMMA] remains below about 0.2, which means that the fraction of incident power entering the switch 1 remains above 96%.

Full browser ?