induced voltage

induced voltage

[in′düst ′vōl·tij]
(electromagnetism)
A voltage produced by electromagnetic or electrostatic induction. Also known as induced potential.
References in periodicals archive ?
2017) the response to the electromagnetic signals generated from the outside anomaly of the borehole is different: for the loops directly facing anomaly, the signal of reply value is positive; for the loops reversely facing anomaly, the induced voltage is negative.
The purpose of the proposed circuit combination is to limit the overvoltage on the MOSFETs (by limiting the dI/dt in the inductor) therefore the induced voltage on the switches with and without the proposed circuit has been evaluated and is presented in Fig.
This law states that the induced voltage inside the coils is caused by the alternation of the magnetic flux flowing through them.
Even if the load is placed in the center of three-phase primary coils, the induced voltage [u'.
All low-level signals are subject to thermally induced voltage offsets based on the Seebeck effect.
When switch 'S' is on, the primary winding of the transformer gets connected to the input At this time the diode 'D' connected in series with the secondary winding gets reverse biased due to the induced voltage in the secondary.
The capacitance coupling the body to the HV lines combined with its capacitance to ground dictates the induced voltage levels.
This leads to a situation where using only the maximum induced voltage is not sufficient to obtain the X factor.
Subsequent coverage includes ground resistance, general hazards, induced voltage due to electric and magnetic fields, de-energized and live-line work, arc flash, and atmospheric discharge, among other topics.
c] and [beta][DELTA]z [down arrow] 0, we find the low-frequency, either-end induced voltage to be
cap] represent for the induced voltage due to the inductive coupling and the induced current source due to the capacitive coupling, respectively.
With the coupling process described as above, the induced voltage and current of the outer transmission-line system composed of the shield's exterior and the ground should be determined first.