Make a small
inspection hole and ensure there is no build up of loose sand and plaster.
If they get bigger, strip the paper and create a fist–sized
inspection hole which can be easily covered over with a plasterboard patch.
A limb-bolt
inspection hole is designed right into the riser so you can keep an eye on the bolt positioning.
I Cut a small
inspection hole and use a compact mirror and flashlight to peek inside the wall.
When the chamber is loaded, a red colored plug emerges from this
inspection hole. In terms of feel, it sticks out only slightly and it is not one that is extremely "proud," so practice is recommended.
The submitter suggests a rudder
inspection hole be engineered so maintenance can easily inspect the torque tube for corrosion.
We discovered it when we went to spread manure and engine oil poured out of the clutch
inspection hole. We had a new seal put in there and in every compartment that we opened, just to make sure.
"In soft ground, potholing is a no-brainer and under pavement the extra couple of hundred dollars it costs to cut, vacuum and permanently reinstate a cored
inspection hole, pales in comparison to the damage that could result if the directional drilling crew hits another utility."
The custody sergeant agreed it was very warm and, as an act of kindness, he left the wicket gate
inspection hole in the door open for him to get some fresh air.
Pc Edwards said he had not actually entered the cell but looked through the
inspection hole in the door and saw that Mr Iles was snoring and breathing.
MOR-GL for poles with no
inspection holes averaged 41.44 MPa, while average MORs for poles receiving any of the
inspection hole treatments ranged from 39.48 to 40.43 MPa (Table 1).
Peering into the hole, I immediately found the culprit: Someone thought it would be a brilliant idea to stuff rags into the
inspection hole rather than replace the panel.