liquid line

liquid line

A tube or pipe carrying the refrigerant liquid from the condenser or receiver of a refrigeration system to a pressure-reducing device.
References in periodicals archive ?
Tenders are invited for welding job of sphere-02 (585 mt) for replacement of main liquid line (200mm nb) at lpg hariyala plant
It chose the Eriez Xtreme[R] Liquid Line metal detector, which now inspects 80,000 lb of different FSS sauces for contamination on a daily basis.
This warm high pressure liquid is pumped through a smaller copper tube (liquid line) to a filter (or filter/dryer) and then on to an expansion device where the high pressure liquid is reduced to a cold, low pressure liquid.
At presstime, FSS was preparing for installation of a second Eriez Xtreme Liquid Line metal detector.
The pressure-enthalpy chart for a refrigerant contains a couple of boundary lines, representing the heat content of the fluid when it is liquid on the point of boiling (the saturated liquid line) and when it is gas on the point of condensing (the saturated vapor line).
Liquid line consists of liquid reservoir with temperature regulation and laboratory pump which drives the working fluid through distributor towards the target surface.
Table 1: Collection of Intentions &Nodes INTENTION 1 : LPG UNLOADING AND STORING IN SPHERE NODES Description A : LPG LIQUID LINE FROM WAGON UNLOADING GANTRY TO SPHERE B : LPG LIQUID LINE FROM TANKER UNLOADING GANTRY TO SPHERE C : LPG VAPOUR LINE CONNECTING WAGON UNLOADING GANTRY AND COMPRESSOR D : LPG VAPOUR LINE CONNECTING TANKER UNLOADING GANTRY AND COMPRESSOR E : LPG VAPOUR LINE CONNECTING SPHERE AND COMPRESSOR INTENTION 2 : LPG DELIVERY FROM SPHERE FOR DISTRIBUTION NODES : Description A : LPG LIQUID LINE CONNECTING SPHERE AND VAPOURISER B : STEAM LINE FOR HEATING LIQUID LPG IN VAPOURISER C : LPG VAPOUR BY-PASS LINE CONNECTING COMPRESSOR & VAPOURISER HEADER Conclusion:
The refrigerant is shipped in compressed cylinders with pressures up to 500 psig and is charged from the liquid line to the system according to the manufacturer's recommendation.
Some of these features are evaporator and condenser volumetric airflow rate for evaporator and condenser fouling; predicted compressor discharge temperature for compressor valve leakage; a refrigerant charge indicator to detect incorrect refrigerant charge; and pressure difference across the expansion valve was used to detect liquid line restriction.
This allowed us to service the condensers such that we maintained the liquid line temperature and pressure that was realized during the tests performed by the manufacturer while rating the product.
The International Monetary Fund reaffirmed Morocco's continued qualification to access to a two-year Precautionary Liquid Line resources, of about US$ 6.2 billion, approved on August 3, 2012.
General strategies for charge reduction are (i) use of indirect system, (ii) use of low-pressure receiver in the suction line rather than the common high pressure receiver in the liquid line and proper receivers sizing, (iii) capillary tube used as expansion device, the diameters and lengths of pipes, (iv) use compressor with small internal volume and small oil charge, (v) use nonmiscible oils, (vi) use of compact, low-volume heat exchangers, preferably minichannel heat exchangers, (vii) use evaporator's direct expansion supplying.