maximum working pressure


Also found in: Acronyms.

maximum working pressure

The maximum pressure at which piping materials of the “standard” or “normally used” type are safe to use.
References in periodicals archive ?
Maximum working pressure is 10 bar/145 PSI, and the units provide thrust forces of up to 3,000N for both versions.
At rest the two muscles are inflated by the same pressure [p.sub.0] equal to 1/2 of the maximum working pressure, thus achieving length [L.sub.0].
for use at 1450 psi; identification coding for manifolds used in hydraulic systems and for component installation features of such manifolds; data specifications for inclusion in the manufacturer's supplier literature that accompanies any kind of pneumatic valve; and an establishment of a metric series of single rod pneumatic compact cylinders for use at a maximum working pressure of 145 psi, with and without magnetic function.
The XP also features a 2.75 inch thick plug top held in place by two 30,000 PSI extra heavy duty retaining rings designed to withstand shock loads four times the maximum working pressure. More info: Blacoh Fluid Control (909) 342-3100, (800) 603-7867; Fax: (909) 342-3101; E-mail: sales@blacoh.com; Web: www.blacoh.com.
This D.O.T.-certified aluminum air tank can be easily filled to a maximum working pressure of 2,800 psi (195 bar) via either a SCUBA tank or a special hand pump.
The plastic cylinder was pressure tested to ten times the brake's maximum working pressure. A stroke wear test was also conducted and detected very little wear after one million cycles at 75%--100% of the maximum pressure output of the master cylinder, reports RTP.
Pressure testing on the plastic brake cylinder has been successful at ten times the maximum working pressure. A stroke wear test run at 75-100% maximum pressure produced very little wear after 1 million cycles.
The AC-630 has a maximum working pressure of 25 psig, and has an accuracy of +/- 1% with an accuracy retention of +/- 2% over the life of the meter.
Glass-filled polypropylene offers chemical resistance to most acids and has a normal operating range from 10[degrees]F to 180[degrees]F and maximum working pressure of 125 psi at 70[degrees]F Glass-filled nylon resists chemicals, provides strength and durability, and resists thread seizure and cross-threading.
Designed for higher maximum working pressure, the air and oil separator is equipped with a high pressure sealed and certified safety valve plus automatic blow-down valve.
Now available with imperial bolt sizes of 1 A--inch to 4-inch and metric bolt sizes of M30 to M100, the SBT range consists of 22 imperial and 26 metric models, each with a maximum working pressure of 21,750 PSI (1500 Bar).

Full browser ?