density(redirected from microvessel density)
Also found in: Dictionary, Thesaurus, Medical, Financial.
density,ratio of the massmass,
in physics, the quantity of matter in a body regardless of its volume or of any forces acting on it. The term should not be confused with weight, which is the measure of the force of gravity (see gravitation) acting on a body.
..... Click the link for more information. of a substance to its volume, expressed, for example, in units of grams per cubic centimeter or pounds per cubic foot. The density of a pure substance varies little from sample to sample and is often considered a characteristic property of the substance. Most substances undergo expansion when heated and therefore have lower densities at higher temperatures. Many substances, especially gases, can be compressed into a smaller volume by increasing the pressure acting on them. For these reasons, the temperature and pressure at which the density of a substance is measured are usually specified. The density of a gas is often converted mathematically to what it would be at a standard temperature and pressure (see STP). Water is unusual in that it expands, and thus decreases in density, as it is cooled below 3.98°C; (its temperature of maximum density). Density often is taken as an indication of how "heavy" a substance is. Iron is denser than cork, since a given volume of iron is more massive (and weighs more) than the same volume of cork. It is often said that iron is "heavier" than cork, although a large volume of cork obviously can be more massive and thus be heavier (i.e., weigh more) than a small volume of iron. See specific gravityspecific gravity,
ratio of the weight of a given volume of a substance to the weight of an equal volume of some reference substance, or, equivalently, the ratio of the masses of equal volumes of the two substances.
..... Click the link for more information. .
The mass per unit volume of a material. The term is applicable to mixtures and pure substances and to matter in the solid, liquid, gaseous, or plasma state. Density of all matter depends on temperature; the density of a mixture may depend on its composition, and the density of a gas on its pressure. Common units of density are grams per cubic centimeter, and slugs or pounds per cubic foot. The specific gravity of a material is defined as the ratio of its density to the density of some standard material, such as water at a specified temperature, for example, 60°F (15.6°C), or, for gases the basis may be air at standard temperature and pressure. Another related concept is weight density, which is defined as the weight of a unit volume of the material. See Mass, Weight
in textiles, the content of fibrous material per unit volume. The density of a weave determines the strength and appearance of the fabric. It is usually expressed by the number of warp threads per unit of width and the number of filling threads per unit of length—that is, the ratio of absolute density along warp and filling. When the linear density (fineness) of the threads varies, a ratio of relative density is used, expressed by a filling coefficient—linear, surface, or volume—representing the relationship of the linear measurements of surface or volume to the overall width, length, surface, or volume of a unit of material. The relative density is determined basically by the type of fiber interlacing used in the weave. For a weave of normal density, about 40 or 50 percent of the volume of a fabric consists of fibrous material.
bit densityThe number of binary digits (bits) that can be stored within a given memory or storage area. See bit and bpi.
|One Memory Cell|
|This is one bit in an early 16MB dynamic RAM (DRAM) chip. Although a thousand times less dense compared to today, there were nevertheless 16,777,216 cells in the quarter-inch-square chip. (Image courtesy of IBM.)|