millivolt


Also found in: Dictionary, Thesaurus, Medical, Financial, Acronyms, Wikipedia.

millivolt

[′mil·ə‚vōlt]
(electricity)
A unit of potential difference or emf equal to one-thousandth of a volt. Abbreviated mV.
References in periodicals archive ?
Si preparations have already been shown to interfere with ISE determinations of ionized magnesium: Blood specimens obtained through tubing or syringes coated with silicone spuriously increased the concentration of ionized magnesium measured with an AVL 688-4 instrument, as documented by an increase in the millivolt reading from the electrode [5].
The demands would require OEMs to specify a millivolt output or amplified pressure sensor, fully calibrated and temperature compensated.
A melt-pressure transducer measures pressure and gives a raw signal in millivolt output.
For many years, millivolt, or standing pilot heaters, were the only kinds of heaters available.
If your application requires the recording of millivolt or volt signals, a flatbed or vertical-face recorder with a standard input range of 1 mV to 5 V, including 10 selectable voltages within this range, would be a good choice.
oil capacity, millivolt control only, stainless steel tank & exterior, 110,000 btu, nsf, ce, csa flame, csa star, auga (free standing, standalone only fryer).
As mentioned previously, the electrodes placed on the skin of the patient may have a DC potential on the order of several hundred millivolts, while the signal of interest is typically less than one millivolt.
All Sensors (Morgan Hill, CA) has announced a new line of Millivolt Low Voltage Pressure Sensors.
The LRX accepts a three-wire 100 ohm platinum RTD, K-type thermocouple, or direct millivolt input.
The unit accepts a three-wire 100 Ohm platinum RTD, K-type thermocouple, or direct millivolt input.
Direct control of an ozonator with the Model 305 ensures a minimum ozone level, and millivolt readout provides precise verification of ozone addition.
Developers and service engineers investigating the noise characteristics of components in these types of circuits must measure signals in the millivolt range.