motion cycle

motion cycle

[′mō·shən ‚sī·kəl]
(industrial engineering)
The complete sequence of motions and activities required to complete one work cycle.
References in periodicals archive ?
One limb motion cycle (arm swing cycle) starts when the arm swings to the very backward position, and ends after the arm swing forward and back to the very backward position again.
In the virtual prototype of quadruped robot in this paper, the lengths of thigh and shank are l = 0.14 m, the speed of walk gait is v = 0.12 [ms.sup.-1], and the motion cycle is T = 1.5 s.
Today on the ground, the ramifications of these policies are playing out in a slow motion cycle of desperation and despair.
Robotic simulation, in conjunction with external robot controller software, can be used to generate accurate motion cycle time.
The basic principle is that control is only needed at certain times in the valve's plate motion cycle, just prior to the opening and closing impacts of the plate.
For example, a high-resolution feedback option in the controller improves positioning accuracy and reduces motion cycle time.
On this trial, we defined the condition of bench steering-motion fatigue test as: temperature 100 [degrees] C, pressure 9.8 MPa, pressure cycle 42 cycles/minute, steering motion cycle 100 cycles/minute.
Pressure distributions along stationary engine case and rotor rim surface of Rampressor inlet in a whirling motion cycle are shown in Figure 13 when rotor whirl amplitude equals 100 [micro]m and whirl speed ([ohm0]) is 4250 rad/s.
(3) In two consecutive motion cycles, there is not any speed regulating or pausing; it means that the RPTM is less than the patient's current period capacity; then the RPTM is increased in the next cycle.
Let the moving platform continuously operate four motion cycles along with the given circle trajectory Equation (32).
Mechanical technician Chris, aged 46, from Northfield, is now set to take delivery of his Motion cycles, worth more than pounds 500.
Within three motion cycles, the model keeps undulating under constant motion parameters for another three motion cycles.

Full browser ?