The presented investigation show one limited approach, mostly regarding selected high-strength steel(s) (its
nominal strength values), and simulation used only for further evaluation of hardness and toughness.
Both the
nominal strength and deformation capacities of corroded high strength bars tended to decrease with increasing corrosion degree.
Tensile strength of H 150 x 75 x 5 x 7 (MPa) Tensile test Nominal yield stress Component [f.sub.y] [f.sub.u] 271.9 377.9 250 Flange 273.7 377.1 271.9 371 Average 272.5 375.3 295.7 390.2 Web 290.5 392.9 289.6 387.6 Average 291.9 390.2 Concrete compressive strength (MPa) [f'.sub.c]
Nominal strength Side 1 Side 2 39.0 37.4 40.1 38.8 38.4 40 30 40.9 40.2 42.4 39.3 32.8 39.6 37.1 38.5 34.7 36 Average 38.1 38.8 38.4 TABLE 3: Test result of test specimens.
the 7 readings match the results of the calibration for the C40 concrete mix towards 80 percent of
nominal strength (32 mPa) being reached within ~ 3 days and full design strength (40 mPa) within less than one week (average after ~ 5 days) they, too, are prove for a very consistent concrete quality
Based on calculation of the
nominal strength of the plywood and wood screw connection using Load and Resistance Factor Design procedures, the tensile capacity of the six #8 screws in single shear is 857 pounds.
The prediction of
nominal strength of composites structure take care a lot of investigations because of its importance in design of aerospace and automobile (1-3).
The variables considered are: span-to-depth ratio a/d (ranging from 2.50 to 5.50), axial load ratio N/[N.sub.0] (ranging from 0.07 to 0.63), compressive strength of concrete [f.sub.c] (ranging from 27.40 to 115.80 MPa), main longitudinal reinforcement ratio p (ranging from 1.67% to 3.81%),
nominal strength of stirrup [[rho].sub.w][f.sub.yw] (ranging from 0.55 to 12.76) and size effect d/[d.sub.a] (ranging from 7.06 to 19.50).
Analysts at the International Institute for Strategic Studies have estimated that despite a
nominal strength of some 200 fixed-wing aircraft, fewer than 40 are actually capable of flying.
In this experiment, it is resulted that the
nominal strength of one thread is 6.7926 kN and the power of the amount of the thread is 1.37.
US combat doctrine maintains that units at less than 90% of their strength are limited in what missions they can undertake, and that units at 75% of their strength should be withdrawn from combat operations until they are restored to their
nominal strength on paper.
Nominal strength is the nominal stress at which a material breaks.