required thickness

required thickness

[ri′kwīrd ′thik·nəs]
(design engineering)
The thickness calculated by recognized formulas for boiler or pressure vessel construction before corrosion allowance is added.
References in periodicals archive ?
Including Digging Soil Leveling the Same Over - 5200m2, Mixing Earth and Manures in Proportions as Directed and Spreading the Same in Required Thickness (Cost of Dump Manure and Good Earth to Be Paid Separately).
covers with A piece could require as many as 100 coats before the required thickness was achieved, the final coat being polished to a the mirror finish using pumice.
In addition, epoxy coats achieve the required thickness and retain film build around sharp edges, which boosts the market growth.
Make the alioli in a food processor - blend the garlic, aquafaba, mustard, vinegar, turmeric (if using) and some salt and then slowly, with the machine still running, drizzle in the oil until the alioli is to the required thickness.
This document addresses many specifications for a chamber such as the required thickness of the acrylic window and minimum pressures it must withstand which are much higher than what we would currently use for therapy.
This would then normally determine the required thickness of the attenuation layer.
For atomised spray application of a wide range of liquid paints and coatings, the required thickness of the film guides the application technique.
In addition, the researchers looked for a simple and repeatable synthesis method that enables easier control on the required thickness.
Amongst other factors, the extent of exposure to corrosives, the required thickness of the floor, what heavy impacts will need to be withstood and the standard of the substrate will all play a role in specifying the right solution for an effective, long-term finish.
The required thickness and strength of the sub-ballast layer of soil mixtures can be obtained by calculation of finite element models of the track [12], Fig.
Nonwovens materials are dried or bonded together in the Santatherm oven, using the variable nozzle and fan systems; the required thickness and weight can be adjusted.
For PU, thermal bridging effect was taken into account while calculating required thickness to achieve target R-value.