reset pulse

reset pulse

[′rē‚set ‚pəls]
(electronics)
A drive pulse that tends to reset a magnetic cell in the storage section of a digital computer.
A pulse used to reset an electronic counter to zero or to some predetermined position.
References in periodicals archive ?
The infusion head uses the Deep Derma Infusion, which combines four different signals (infusion pulse, reset pulse, treatment pulse and micro oscillation) to get more firm and resilient skin.
This new solution generates a reset pulse for a factory-programmed reset timeout period after both manual reset inputs have been held logic-low for the factory-programmed setup period.
Communication starts by the master initiating the RESET pulse. Connected slaves report their presence on the bus by holding the bus level at active value--logical 0.
Visitors can also see the FT7521L6X reset timer with fixed delay and reset pulse; the FAN54013 USB boost regulator with a highly integrated switched-mode charger to minimize single-cell Lithium-ion (Li-ion) charging time from a USB power source; and the FSA8008A audio jack detector and switch for 3- or 4-pole accessories featuring an integrated MIC switch that allows the processor to configure the audio jack.
A reset pulse is sent first, followed by a set pulse few milliseconds later.
While in power-down mode, the LinkZero-AX allows the IC to be awakened with a reset pulse or button press.
Offset (Voff) is computed from the "set pulse" output voltage (Vset) and the "reset pulse" output voltage (Vreset) by (1).
In reset mode, it issues a reset pulse to reset all the counters to zero.
Note, the latching G9YA model saves power by requiring only a set or reset pulse to change operating states.
Table I and Table II show the number of write positive pulses required after the reset pulse to reach a certain state x as a preparation for the read by negative and complementary pulses respectively.
The switching time is determined by the sum of the maximum reset pulse width, the dead time between reset and set, and the maximum set pulse width.
The triggering set and reset pulses in SFM mode generate a proper duty ratio and a switching frequency.