# setting angle

## setting angle

[′sed·iŋ ‚aŋ·gəl]
(mechanical engineering)
The angle, usually 90°, between the straight portion of the tool shank of the machined portion of the work.
McGraw-Hill Dictionary of Scientific & Technical Terms, 6E, Copyright © 2003 by The McGraw-Hill Companies, Inc.
Mentioned in ?
References in periodicals archive ?
Compared with the OGV setting angle [theta] = 0[degrees], the hydraulic loss of OGV increases approximately by 55%, the hydraulic efficiency of pump decreases approximately by 1% at [theta] = 2.5[degrees] and [theta] = 5[degrees], and the hydraulic loss of OGV increases by 118.55%, and the hydraulic efficiency of pump decreases by 4.86% at [theta] = 10[degrees].
The manual B-axis setting angle is [+ or -]1[degrees].
The inserts can be set to a true 90[degrees] setting angle. The inserts lock into place with a center screw placed in the same direction as the cutting forces.
Maximum cutting depth is 0.078" and the setting angle is between 0 and 15 degrees depending on the cutting depth.
The actuator series is fitted with a special standard position control system which allows the exact adjustment and control of the setting angle once the valve has been installed into the pipeline.
Maximum cutting depth is 0.078" and the setting angle ranges between 0 and 15 degrees, depending on cutting depth.
Blade Setting Angle: When a slot is provided in the cutter body for a blade, the angle between the base of the slot and the cutter axis is called the blade setting angle.
The severe disorder that is the dominant feature of both WAXD patterns may be mainly due to lack of coherence in the setting angles of neighboring molecules.
You'll need a roll of soft wire, which you can buy at a hardware store or home center, a driver drill, dropcloths and a protractor (desk models are fine) for setting angles on your saw.
The 72-position index plate allows hard index every five degrees and there is a built-in sine bar for setting angles between hard index locations.
MC chipbreakers are available with setting angles of 6 degrees and 15 degrees, eliminating work piece burrs.

Site: Follow: Share:
Open / Close