signal voltage

signal voltage

[′sig·nəl ‚vōl·tij]
(electricity)
Effective (root-mean-square) voltage value of a signal.
References in periodicals archive ?
In addition, the low-level signal voltage has been increased to five volts to provide more headroom for add-on amplifiers.
This indicates that the MI effect is the biggest for the first peak even though the variation of output signal voltage is the biggest for the second peak in a uniform geomagnetic field in a longitudinal sensor geometry.
Because DFE uses the digital bits from the sequence, and because these bits are determined based on the signal voltage at the sampling point being compared with the threshold, there is a possibility due to noise that the bit gets incorrectly assessed.
As speeds of multi-slot memory subsystems increase, ring-back and cross-talk compromise the quality of the signal voltage amplitude thereby making it difficult to recognize the logic level of the signal.
This reading and the signal voltage are transmitted to the oscilloscope and displayed, enabling the DC level and ripple to be measured in parallel when qualifying power supplies for highly sensitive electronic components such as CPUs and FPGAs.
For the measurements shown, the small signal voltage was only about 1 V and the current was less than 1 A.
However, each value of such signal voltage corresponds with two different values of condensate resistance.
On the negative half-cycle of the input signal voltage, a capacitor [C.sub.4] is charged through the diode [D.sub.1] to a peak signal voltage.
To this end, the work is organized as follows: In Section 2, we present the characteristics of the NLTL under consideration and derive the circuit's equations governing the dynamics of signal voltage in the network.
The control stage is responsible for maintaining a load current controlled that depends on the supplied reference signal, this control action is performed on the signal voltage [V.sub.GS] of the power MOSFET.
For the FEXT to be dimensionless, as the ratio of the noise voltage to the signal voltage, kf has to have units of nsec/in., which is 1/velocity.
The signal voltage attenuation in decibels was measured with the voltage logarithm of the ratio of the signal voltage on the transmitting sensor, [V.sub.transmitting], to the signal voltage on the receiving sensor, [V.sub.receiving] (Eq.

Full browser ?